Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Discussion on Laboratory Test Simulation of Principal Stress Axes Rotation Induced by Traffic Loading

Impact of Shear Stress on Strain and Pore Water Pressure Behavior of Intact Soft Clay under Principal Stress Rotation

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Microstructure Study on Intact Clay Behavior Subjected to Cyclic Principal Stress Rotation

The characteristics and laboratory test simulation of stress path induced by traffic loading

Deformation of Intact Soft Clay under Principal Stress Rotation with Effect of Intermediate Principal Stress

Effects of principal stress rotation and cyclic confining pressure on behavior of soft clay with different frequencies

Deformation behavior of K0-consolidated soft clay under traffic load-induced stress paths

Microstructure Behavior Of Intact Soft Clay After Principal Stress Rotation

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Influence of Shear Stress Level on Cyclic Deformation Behaviour of Intact Wenzhou Soft Clay under Traffic Loading

Critical properties of intact soft clay under cyclic principal stress rotation

Stress–strain Response of Soft Clay to Traffic Loading

Undrained Behaviour of Intact Soft Clay under Cyclic Paths That Match Vehicle Loading Conditions

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

Influences of Stress Magnitude and Loading Frequency on Cyclic Behavior of K0-consolidated Marine Clay Involving Principal Stress Rotation

Intact soft clay responses to cyclic principal stress rotation in undrained Condition

Effects of Cyclic Intermediate Principal Stress on the Deformation of Saturated Clay

Influence of Initial State and Intermediate Principal Stress on Undrained Behavior of Soft Clay During Pure Principal Stress Rotation

Deformation behaviors of sandy subgrade soil under traffic load-induced stress path

STRESS STATE VARIATION AND PRINCIPAL STRESS AXES ROTATION OF GROUND INDUCED BY MOVING LOADS