Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Development of A Large-Scale Cyclic Simple Shear Test Apparatus

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Low-Cycle Fatigue Test of Circular Concrete Filled Tubular Columns

Study Of Shear Strength Characteristics Of Simulation Rock Structural Planes Based On Multi-Size Direct Shear Tests

Triaxial Hybrid Simulation and Cyclic Tests of Full-Scale Circular Steel Tube Columns

Large-Scale Apparatus for Monotonic and Cyclic Soil-Structure Interface Test

Development and application of novel hollow cylinder apparatus

Experimental research on reinforcement-soil interface stiffness and damping ratio under cyclic shearing

Cyclic Behavior of Saturated Soft Clay under Stress Path with Bidirectional Shear Stresses

Effect of Drained Static Shear on Cyclic Deformation Behavior of K-0-consolidated Sand

Preliminary Study of Dynamic Testing Performance of Hollow Cylinder Apparatus

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Experimental research on long-term dynamic characteristics of unsaturated road base and subbase mixtures

An Automated Large-Scale Apparatus for 3-D Cyclic Testing of Soil-Structure Interfaces

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Energy-based Evaluation of Undrained Cyclic Behavior of Marine Soft Clay under Multidirectional Simple Shear Stress Paths

Development of a Large-scale Computer-controlledCompression-torsional Multi-axial Loading Apparatus

Cyclic shear behavior of dredged soil under constant normal stress conditions

Cyclic triaxial tests with controlled elastic shear modulus of specimen

A New Apparatus for Shear-Seepage Testing at the Clayey Soil-Structure Interface

Experimental Investigation into Cyclic Shear Behaviors in the Interface Between Steel and Crushed Mudstone Particles