Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

3D numerical simulation of particle breakage using discrete element method

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

A coupled FEM-DEM study on mechanical behaviors of granular soils considering particle breakage

Three-Dimensional Discrete Element Analysis of Crushing Characteristics of Calcareous Sand Particles

DEM Modeling of Particle Breakage in Silica Sands under One-Dimensional Compression

DEM studies on the effect of particle breakage on the critical state behaviours of granular soils under undrained shear conditions

DEM Investigation of Fracture Characteristic of Calcareous Sand Particles Under Dynamic Compression

Discrete Numerical Modeling of Granular Materials Considering Crushability

Study Of Evolution Of Sand Crushability Based On Discrete Elements Method

Micro-mechanical analysis of caisson foundation in sand using DEM: Particle breakage effect

DEM study on the microscale and macroscale shear behaviours of granular materials with breakable and irregularly shaped particles

Simulation Study of Breakage in Coral Sand Particles under Dynamic Confined Compression

Study on the Mechanical Behavior of Sands Using 3D Discrete Element Method with Realistic Particle Models

Experimental and numerical study on the fragmentation mechanism of a single calcareous sand particle under normal compression

Discrete element simulation of effects of multicontact loading on single particle crushing

Numerical simulation of triaxial test on the dense sand by DEM

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Three-dimensional discrete element simulation of random breaking strength and size effect in single particle splitting test of rockfll

Single-particle Crushing Behaviour of Carbonate Sands Studied by X-ray Microtomography and a Combined Finite–discrete Element Method

3D DEM Method for Compaction and Breakage Characteristics Simulation of Broken Rock Mass in Goaf

Study on the Particle Breakage of Ballast Based on a GPU Accelerated Discrete Element Method