Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Discrete element simulation of effects of multicontact loading on single particle crushing

Contact Force Distribution and Induced Anisotropy in Granular Materials under Biaxial Test

Mesoscopic numerical test of crushing process of concrete under uniaxial compression

A Network-Based Investigation on the Strong Contact System of Granular Materials under Isotropic and Deviatoric Stress States

Multiscale modeling of continuous crushing of granular media: the role of grain microstructure

Three-Dimensional Discrete Element Analysis of Crushing Characteristics of Calcareous Sand Particles

A Micro‐macromechanical Compression Model of Crushing in Granular Materials Based on a Probabilistic Approach and Energy Aspects

Complex Network Analysis of Force Chain Structure for Granular Materials under Loading and Unloading Conditions

Cohesive zone method based multi particle finite element simulation of compaction densification process of Al and NaCl laminar composite powders

Experimental study and theoretical analysis on ballast particle crushing based on energy dissipation and release

Grain Crush and Its Evolution in Granular Material: a Two-Dimensional Distinct Element Model Approach

Effect of modeling parameters on the mechanical response of macroscopic crushing of agglomerate

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Impact of Particle Shape on Crushing Behaviour of Rock Particles Using X-ray Micro-CT Testing and DEM Modelling

Influence of Load Mode on Particle Crushing Characteristics of Silica Sand at High Stresses

Micromechanical Investigation of Particle Breakage Behavior in Confined Compression Tests

Fractal Pattern of Particle Crushing of Granular Geomaterials during One-Dimensional Compression

Crushing and Flooding Effects on One-Dimensional Time-Dependent Behaviors of a Granular Soil

Effect of the intermediate principal stress on the mechanical behaviour of breakable granular materials using realistic particle models

Investigating the effects of elongation and flatness on the shear behaviour of breakable granular materials via the DEM

Investigation of morphological effects on crushing characteristics of calcareous sand particle by 3D image analysis with spherical harmonics