Abstract:Crucial mechanical-chemical (MC) interactions occur during the cement hydration process in cement marine clay; however, the role of such an important element of the resulting strength has been subject to less investigation, particularly from the theoretical perspective. To overcome this scientific gap, an efficient strength-based model accounting for the coupled MC processes is proposed here. Based on the analysis of the cement hydration mechanism, the porosity was chosen as the main factor to characterize the influence of the MC interactions on the overall response. To verify the accuracy of the MC model, the unconfined compressive strength (UCS) experiment was conducted for the cement marine clay samples, and the corresponding simulation model was constructed using COMSOL multiphysics®. In addition, a comparison between the predicted results by the existing three strength models and the proposed MC model was performed. Subsequently, the sensitivity analysis and identification of mechanical parameters were carefully carried out. The obtained results show that the UCS strength for Taizhou clay ranges from 10.21 kPa to 354.2 kPa as the cement content increases from 10% to 20%, and the curing time varies from 3 days to 28 days. The mechanical parameters in the MC model can be obtained according to the porosity level. A reasonably good agreement between the UCS strength results of simulations and the experimentally observed data is reported. Additionally, the predicted UCS strength results by the MC model demonstrate the best correspondence with the measured values, indicating the high efficacy of the established model.

Research on tensile-shear coupling strength of unsaturated clays

A Novel Strength Model for Cement Marine Clay Based on the Mechanical-Chemical Coupling Behavior

Direct Shear Test and Shear Strength Model of Clay-Filled Joints

Modified Duncan-Chang Model Considering Physical Properties of Saturated Clays

Experimental Study on Shear Strength Considering Initial Void Ratio and Plasticity Index

An Anisotropic Egg-Shaped Bounding Surface Model for Saturated Soft Clay

COUPLING EFFECTS OF INITIAL SHEAR STRESS AND LOADING RATE ON STRENGTH BEHAVIORS OF SATURATED SOFT CLAY

VARIATION OF THE SHEAR STRENGTH OF XIAMEN UNSATURATED RESIDUAL SOILS WITH WATER CONTENT

A Unified Thermo-Mechanical Bounding Surface Model for Saturated Clay and Sand

Experimental and Numerical Investigation on the Tensile Fracture of Compacted Clay

An effective stress-based approach to modeling the hydro-mechanical behavior of unsaturated soils

Thermodynamic constitutive model for anisotropic undrained shear strength of saturated clays

Modeling Temperature-Dependent Behavior of Soft Clay

An effective stress-based approach to modeling the chemo-mechanical behavior of saturated active clay

Shear strength characteristics of an unsaturated expansive clay

A constitutive model for structured soils under saturated and unsaturated conditions

A bounding surface model for saturated and unsaturated soil‐structure interfaces

Experimental Study on the Effects of Matric Suction on Shear Properties of Polypropylene Fiber Reinforced Unsaturated Clay

A Thermodynamic Constitutive Model for Undrained Monotonic and Cyclic Shear Behavior of Saturated Soils

Simulation of Triaxial Tests for Unsaturated Soils under a Tension–Shear State by the Discrete Element Method

Numerical simulation of water content dependent undrained shear strength of clays