Abstract:The soil-water characteristic curve (SWCC) is defined as the relationship between the suction and the water content or degree of saturation. The soil-water characteristics and related mathematical models can be used to model the unsaturated soil properties such as the permeability and the shear strength. Conventionally, only the drying soil-water characteristic curve of soil is determined. In this work, the influences of initial water content, initial dry density, the vertical stress and drying and wetting cycles are examined and discussed in detail. The SWCCs and hysteresis loops of residual soils in Xiamen were obtained by the filter paper method. The results show that the initial water content has negligible effect on SWCCs. The specimen at the wet of optimum moisture content (OMC) has the higher air entry value and the larger hysteresis loop than that of the soil specimen at the dry of OMC. The specimen with OMC lies between them. While, the initial dry density has considerable influence on SWCCs. The specimen at lower initial dry density exhibits smaller air entry value and higher rate of desorption than that of the specimen at higher initial dry density. The size of hysteresis loop decreases as the initial dry density increases. The specimens subjected to different vertical stresses have different SWCCs. The higher the applied load on the specimen, the higher the air entry value, the higher the rate of desorption, the smaller the size of hysteresis loop. In the drying and wetting process, the size of hysteresis loop has been substantially affected by the first drying and wetting cycle. With the increasing of drying and wetting cycle, the air entry value and the size of hysteresis hoop decrease. Since the features of soil-water characteristic of sandy clay are not well defined especially for the residual state of saturation, which desaturates continuously without a distinct break point, the residual suction or residual water content, one of the key parameters in the mathematical models of SWCC, is not well defined. As a result five improved models without the residual water content are proposed to describe the SWCCs of residual soil. The improved Gardner model has been found to be the most suitable model for all SWCCs of the residual sandy clay in Xiamen.

VARIATION OF THE SHEAR STRENGTH OF XIAMEN UNSATURATED RESIDUAL SOILS WITH WATER CONTENT

Shear strength characteristics of an unsaturated expansive clay

Experimental Study on Shear Strength Considering Initial Void Ratio and Plasticity Index

Direct Shear Test and Shear Strength Model of Clay-Filled Joints

Effect of suction on shear strength and dilatancy of an unsaturated expansive clay

Experiment And Modeling Of Soil-Water Characteristic Curve Of Unsaturated Residual Soil

COUPLING EFFECTS OF INITIAL SHEAR STRESS AND LOADING RATE ON STRENGTH BEHAVIORS OF SATURATED SOFT CLAY

Estimation of Soil Shear Strength Indicators Using Soil Physical Properties of Paddy Soils in the Plastic State

Study on the Strength of Expansive Soil Based on Water Content and Dry Wet Cycle

Combined Influences of Water Content and Coarse Grain Content on Shear Strength of Unsaturated Soil Mixture

Experimental Study on Degradation of Stiffness of Saturated Soft Clay under Undrained Cyclic Loading

Experimental Study of Relationship Between Water Content and Strength or Deformation of Slip Soil

Some Problems Concerning Shear Strength of Soil in Soft Clay Ground

Effect of Water Content on Strength of Alluvial Silt in The Lower Yellow River

Dynamic Characteristics of Unsaturated Remolded Sandy Soil Through Cyclic Shear Tests

Water Retention Behavior and Shear Strength of Artificially Cemented Granite Residual Soil Subjected to Free Drying

Shear strength of unsaturated expansive soil during wetting-drying cycles

Effect of the optimum and residual moisture content on the strength characteristics of unsaturated sands

Simplified Method For Determining Shear Strength Of Unsaturated Soils Based On Different Paths

Laboratory Investigation of the Unsaturated Shear Strength Characteristics of Sand–Clay Mixtures

Deformation, strength and water variation characteristics of unsaturated compacted loess