Abstract:Purpose – Rock-fill dams are embankments of compacted free-draining granular earth containing an impervious zone. Earth utilized in such dams often contains a high percentage of large particles – hence the term rock-fill. Mass stability of these dams results from friction and particle interactions rather than through a cementing agent binding the particles together. However, high-stress conditions and prolonged exposure to the elements can severely damage rock-fill. Therefore, understanding and modeling rock-fill breakage is important for dam engineering. The purpose of this paper is to improve discontinuous deformation analysis (DDA) techniques for modeling rock-fill breakage, proving the new method using simulations of spherical particle crushing. Design/methodology/approach – This work models rock-fill as bonded ellipsoid particles, and develops an improved DDA method to model the breakage of particle assemblies. The paper starts by describing the principles of three-dimensional DDA for spherical particles, and then derives the submatrices for normal contact, shear contact, and frictional force. The new algorithm incorporates a bond model with a revised open-close iteration algorithm into the DDA method to simulate particle crushing. To validate the improved DDA method, calculated particle contacts and movements are validated against theoretical results. Finally, this work performs a series of point-loading experimental tests for cement ellipsoid particles of both high and low compression strengths, with the test results compared against the results from corresponding DDA simulations. Findings – In particle crushing tests, the force and displacement show an approximately linear relationship until the crushing point, at which point low compression ellipsoid particles split into several large pieces while the high-compression particles break into many small fragments. The DDA simulation results are in good agreement with the crushing tests, demonstrating the validity of the DDA method for solving particle crushing problems. Although the improved DDA model is applicable to rock-fill particle crushing studies, some issues remain, particularly in increasing calculation efficiency and performing large-scale computations and long real-time simulations. Future research should address these issues. Originality/value – A bond model with a revised open-close iteration algorithm is incorporated into the DDA method. The simulated results shed insight into rock-fill crushing mechanisms, an element of concern in engineering practices.

Numerical simulation of effect of size on crushing strength of rockfill grains using particle flow code

Experimental and numerical investigation of the size effect of rockfill particles on crushing strength

Effect of Aggregate on Cracking Behaviours of Concrete in Mesoscopic Modeling

Numerical study on mechanical properties of grains in rock discontinuity undergoing shear

Three-dimensional discrete element simulation of random breaking strength and size effect in single particle splitting test of rockfll

Experimental investigation of statistical characteristics of elastic mechanical parameters and strength indexes of rockfill particles

Dem Study on the Effect of Particle Breakage on the Macro- and Micro-Behavior of Rockfill Sheared along Different Stress Paths

Numerical simulation and interpretation of the grain size effect on rock strength

Statistical evaluation of the effect of size and strain rate on particle strength of rockfill materials

Numerical simulation of strength size effect of rocks under different loadings

Discrete element simulation of effects of multicontact loading on single particle crushing

Particle Crushing Simulations with Improved Discontinuous Deformation Analysis

Cohesive zone method based multi particle finite element simulation of compaction densification process of Al and NaCl laminar composite powders

DEM Simulation of the Behavior of Rockfill Sheared with Different Intermediate Principle Stress Ratios

DEM Simulation of Shearing Rockfills along Different Stress Paths

Discrete element analysis of the particle shape effect on packing density and strength of rockfills

Role of Particle Breakage in Rockfill Materials: Investigated by Using Combined SBFEM/DEM with Two Different Breakage Models

Impact of Particle Shape on Crushing Behaviour of Rock Particles Using X-ray Micro-CT Testing and DEM Modelling

Numerical simulation of the effect of internal hole defect size on the mechanical properties of limestone

Numerical Simulation on the Size Effect of Compressive Strength and Deformation Parameters of Rock Materials Under Different Confining Pressures

Investigation into the effects of grain size on strength and failure behaviors of granites using a breakable polygonal grain–based model