Abstract:Three types of polyacrylonitrile (PAN) were considered in order to investigate the effect of molecular composition and configuration on the formation of conjugated structures during stabilization and the conversion of that to pseudo-graphite sheets after carbonization. The stabilization process was performed in an inert or oxidative atmosphere with a temperature ramp from 180°Cto 280°C. The thermal behavior was studied by differential scanning calorimetry, and the change of chemical groups and conjugated structures was detected by in situ measurement of infrared (Fourier transform infrared) and ultraviolet–visible spectroscopy, respectively. The carbonization process of the stabilized samples was performed using a thermogravimetric analyzer under nitrogen atmosphere in the temperature range of 150°C–1200°C, and Raman spectra were applied to study the pseudo-graphite sheets of the residuals. It is suggested that the introduction of comonomer or the improvement of the isotactic regularity of the polymer chain are helpful to promote the stabilization reactions and accelerate the formation of conjugated structures rather than the extent of conjugation during stabilization in nitrogen. Moreover, they are also beneficial to obtain higher degree of graphitization and larger size of the pseudo-graphite sheets with less structural defects after carbonization. While stabilization is performed in air, atactic PAN copolymer has the highest extent of stabilization among these three PAN samples, but they are extremely close. PAN samples with comonomer or higher isotacticity still show a little advantage in the formation speed of the conjugated structures. After carbonization, PAN with higher isotacticity has the highest carbon yield and graphitization degree and the largest size of pseudo-graphite sheets with least structural defects. In addition, the presence of oxygen during stabilization is contributory to increase the extent of stabilization and generate some bigger conjugated structures, which leads to obtain higher graphitization degree and larger size of pseudo-graphite sheets, but it also brings more structural defects.

Enhancement of the low-temperature catalytic graphitization of polyacrylonitrile by incorporating Cu nanostructures as plasmonic photocatalyst

Cu1.94S Nanocrystal Superstructure for Photocatalytic Hydrogen Evolution

Oxygen-containing Groups and P Doped Porous Carbon Nitride Nanosheets Towards Enhanced Photocatalytic Activity.

Manipulating the surface-enhanced Raman spectroscopy (SERS) activity and plasmon-driven catalytic efficiency by the control of Ag NP/graphene layers under optical excitation

Effect of precursors on Cu particle distribution in g-C3N4 nanosheets towards efficient photocatalytic degradation and H2 generation

Differentiating Plasmon-Enhanced Chemical Reactions on AgPd Hollow Nanoplates through Surface-Enhanced Raman Spectroscopy

Photoinduced deposition of AuCu cocatalyst and polyaniline conducting layer on graphitic-C3N4 for enhanced CO2 photoreduction

Kinetically Controlled Synthesis of Pd–Cu Janus Nanocrystals with Enriched Surface Structures and Enhanced Catalytic Activities toward CO 2 Reduction

Polymeric carbon nitride loaded with atomic Cu sites for improved CO 2 photocatalytic conversion performance

Size Effect of Cu Nanoparticles in Cu/g-C3N4 Composites on Properties for Highly Efficient Photocatalytic Reduction of CO2 to Methanol

Large-Scale and Selective Synthesis of Carbon Nanofiber Bundles, Curved Carbon Nanofibers and Helical Carbon Nanofibers.

Metal dependence of spontaneous graphitization growth at room temperature

Study on Carbon Nanotubes of Pyrolysis Carbons P for In Situ Catalytic Formation on Expanded Graphite Surface

Investigation on the Electrochemical Catalysis Properties of Ni-decorated Nanoporous Copper Formed by Hybrid Laser Deposition

Sintering behavior of carbon-supported Pt nanoparticles and the effect of surface overcoating

Synthesis and Characterization of Graphite Nanofibers Deposited on Nickel Foams

The formation of conjugated structure and its transformation to pseudo-graphite structure during thermal treatment of polyacrylonitrile

Effect of N, P co-doped activated carbon supported Cu-based catalyst for acetylene hydration

Carbonate-Assisted Hydrothermal Synthesis of Nanoporous Cuo Microstructures and Their Application in Catalysis

Facile Coupling of Content Design and Efficient Modulation on the Activity of CNT-supported PdAgCu Nanoparticle Electrocatalysts: Leaching Lift-Up and Annealing Fall-off

In Situ Study of Copper Electrodeposition on A Single Carbon Fiber