Unravelling the Correlation Between Microphase Separation and Cocrystallization in Thiophene-Selenophene Block Copolymers for Organic Field-Effect Transistors

Xin Shang,Yue Yin,Shuwen Chen,Mingjing Zhu,Dalong Zhai,Xiaofeng Liu,Juan Peng
DOI: https://doi.org/10.1021/acs.macromol.0c01395
IF: 5.5
2020-01-01
Macromolecules
Abstract:: Despite signi fi cant advances in double-crystalline coil − coil block copolymers (BCPs), investigations into double-crystalline all-conjugated rod − rod BCPs have been comparatively fewer and are limited in scope. Moreover, the ability to control the crystalline structures of all-conjugated BCPs may endow the materials and devices with enhanced optoelectronic properties over the two respective constituents. Herein, we report the synthesis of a series of poly(3-hexylthiophene)- block -poly(3-butylselenophene) (P3HT- b -P3BS) BCPs with tunable block ratios and investigate the e ff ects of block ratio and thermal annealing process on their crystallization and microphase-separated structures. These rod − rod BCPs exhibit a sole P3HT crystallization (P3HT/P3BS = 63:37) or individual P3HT and P3BS crystallization (P3HT/P3BS = 55:45 and 42:58) in as-cast thin fi lms, in fl uenced by the block ratio of P3HT/P3BS. Interestingly, upon 200 ° C-annealing (i.e., annealed at the temperature below the melting points of P3HT and P3BS form I blocks), P3HT- b -P3BS (P3HT/P3BS = 63:37) remains the sole P3HT crystallization, while P3HT- b -P3BS (P3HT/ P3BS = 55:45 and 42:58) transforms from two individual P3HT and P3BS crystal domains into cocrystals, accompanied by the phase transition of P3BS block from form II to I. Remarkably, after a higher thermal annealing at 230 ° C (i.e., close to the melting point of P3HT block yet below the melting point of P3BS form I block), the cocrystalline structures originally existing in P3HT- b P3BS (P3HT/P3BS = 55:45 and 42:58) at the 200 ° C-annealing process do not form, and they reverse back to individual P3HT and P3BS form I crystals. Finally, the relationship between various structures of P3HT- b -P3BS and the resulting charge mobilities is clari fi ed. This study provides an insight into the interplay between microphase separation of P3HT- b -P3BS and crystallization of both P3HT and P3BS blocks tailored by the block ratio and thermal annealing temperature and correlates their di ff erent structures with the charge transport properties. high-resolution pattern. Di ff erential scanning calorimetry (DSC) was measured using a TA DSC Q2000 at a heating rate of 10 ° C/min under N 2 fl ow. UV − vis absorption spectra were recorded on PerkinElmer Lambda 750 UV − vis spectropho-tometers. Cyclic Voltammetry (CV) curves were obtained using a CHI 660 Electrochemical Analyzer with a degassed acetonitrile solution of tetrabutylammonium hexa fl uorophosphate (Bu 4 NPF 6 , 0.1 M). Atomic force microscopy (AFM) images were obtained using a Bruker Dimension FastScan in the tapping mode. The samples for AFM measurement were prepared by spin-coating the polymer solutions (10 mg/mL) on silicon wafers at 2000 r/min for 20 s. The charge transport properties of OFETs were measured using a Keithley 4200-SCS in an argon- fi lled glovebox.
What problem does this paper attempt to address?