Abstract:Seeing that FDS is a fire-spreading and smoke transport simulation software widely used in scientific research and engineering projects,this paper has done investigations on how to utilize the case of Steckler room fire test and made some quantitative studies over the mesh independency property by using the relative similarity analysis method.Further discussions have also been made with the sensitivity of the simulation results to the mesh grid in the fire source area,buoyancy plume area and smoke layer area,with the impact of the computational domain on the simulation result properly interpreted.The correlation value of the simulation results tends to increase while defining the mesh grid,and finally falls into the interval between 0.99 and 1.The impact of the mesh grid size on the correlation value of the simulation is likely to be most severe in the fire source area,less in the buoyancy plume area and the least in the smoke layer area.The correlation value of the results gained from the computational domain,the same in value with the Steckler room and that from the extended domain,tends to be relatively low,whereas that between the results in the domain extended to the distinctive size should be rather high.Thus,it can be concluded that the correlation analysis can be expected to become a reasonable method to assess the mesh grid independency.However,the sensitivity to the mesh grid size tends to drop from the combustion region to the smoke layer area,which suggests the grid size shrinking in the fire area is an effective way to gain more accuracy in an acceptable executive time.In addition,the choice of the computational domain may have an evident effect on the air flow-in and flow-out in the room, which is likely to further impact the temperature and velocity distribution in the building.Therefore,reasonable extension of the computational domain has been proved to be necessary to acquire accurate results.

CFD NUMERICAL SIMULATION OF TEMPERATURE AND AIRFLOW DISTRIBUTION IN PIGSTY BASED ON GRID INDEPENDENCE VERIFICATION

Numerical Simulation of Airflow Pattern at Different Height of Bar in the Piggery Based on CFX

Verification of Anisotropic Mesh Adaptation for Unsteady Mixing and Reacting Flow

Improvement of Grid Independence Test for Computational Fluid Dynamics Model of Building Based on Grid Resolution

Air Temperature and Airflow Simulation in the Weanling Barn Based on CFX

Numerical Simulation in the Piggery under Vertical Ventilation

Effects of Different Ventilation Modes and Outlet Height on Nursery Piggery Environment

Numerical Simulation of Vertical and Horizontal Ventilation in the Piggery Based on CFX

Comptex Grid Generation of an Aircraft and N-S Equations Simulation

Study on convective heat transfer from pig models by CFD in a virtual wind tunnel

Numerical Simulation Of Natural Ventilation In Typical Piggery Of South-East China

Simulation of Flow and Heat Transfer in Micro Couette Flow

Grid Dependency and Convergence of Hypersonic Aerothermal Simulation

CFD Turbulent Model and Grid Dependency of Hypersonic Aerodynamic Heating Calculation Accuracy

Numerical simulation of the standard model CHN-T1 based on overset grid

Summary of Best Guidelines and Validation of Cfd Modeling in Livestock Buildings to Ensure Prediction Quality

Influence of Mesh Grid and Computational Domain on FDS Simulation

The Research Analysis of Aerodynamic Numerical Simulation of Grid Fin

Numerical Simulation of High-Lift Airfoils at Low Speed Based on Overset Grid

Flow Simulations by Enhanced Implicit-Hole-Cutting Method on Overset Grids

CFD Simulation of Indoor Hygrothermal Environment and Particle Matter of Weaned Pig Building