Abstract:Abstract The limit of dynamic endurance during repetitive contractions has been referred to as the point of muscle fatigue, which can be measured by mechanical and electrophysiological parameters combined with subjective estimates of load tolerance for revealing the human real-world capacity required to work continuously. In this study, an isotonic muscular endurance (IME) testing protocol under a psychophysiological fatigue criterion was developed for measuring the retentive capacity of the power output of lower limb muscles. Additionally, to guide the development of electrophysiological evaluation methods, linear and non-linear techniques for creating surface electromyography (sEMG) models were compared in terms of their ability to estimate muscle fatigue. Forty healthy college-aged males performed three trials of an isometric peak torque test and one trial of an IME test for the plantar flexors and knee and hip extensors. Meanwhile, sEMG activity was recorded from the medial gastrocnemius, lateral gastrocnemius, vastus medialis, rectus femoris, vastus lateralis, gluteus maximus, and biceps femoris of the right leg muscles. Linear techniques (amplitude-based parameters, spectral parameters, and instantaneous frequency parameters) and non-linear techniques (a multi-layer perception neural network) were used to predict the time-dependent power output during dynamic contractions. Two mechanical manifestations of muscle fatigue were observed in the IME tests, including power output reduction between the beginning and end of the test and time-dependent progressive power loss. Compared with linear mapping (linear regression) alone or a combination of sEMG variables, non-linear mapping of power loss during dynamic contractions showed significantly higher signal-to-noise ratios and correlation coefficients between the actual and estimated power output. Muscular endurance required in real-world activities can be measured by considering the amount of work produced or the activity duration via the recommended IME testing protocol under a psychophysiological termination criterion. Non-linear mapping techniques provide more powerful mapping of power loss compared with linear mapping in the IME testing protocol.

Determining Endurance Limit Under Intermittent Physical Operations Based on a Combined Fatigue-Recovery Model.

Novel Approach to Estimate Endurance Limits in Intermittent Tasks

A Work-Rest Allowance Model Based Individual Fatigue And Recovery Attributes

Determination of subject-specific muscle fatigue rates under static fatiguing operations

Continuous Measurement of Muscle Fatigue Using Wearable Sensors During Light Manual Operations.

A new simple dynamic muscle fatigue model and its validation

Evaluation of Running Intensity and Fatigue Degree Based on Human Physiological Information

A new muscle fatigue and recovery model and its ergonomics application in human simulation

Experimental Validation of a Subject-Specific Maximum Endurance Time Model.

A novel approach for determining fatigue resistances of different muscle groups in static cases

Measurement of Subject-Specific Local Muscle Fatigability

Framework for Dynamic Evaluation of Muscle Fatigue in Manual Handling Work

A New Simple Local Muscle Recovery Model and Its Theoretical and Experimental Validation

Dynamic Muscle Fatigue Evaluation in Virtual Working Environment

Human Reliability Modeling in Occupational Environments Toward a Safe and Productive Operator 4.0

Retentive capacity of power output and linear versus non-linear mapping of power loss in the isotonic muscular endurance test

Human Muscle Fatigue Model in Dynamic Motions

A new approach to muscle fatigue evaluation for Push/Pull task

Modeling of Maximum Endurance Time for Static Pulling Tasks.

Individualisation Method of Biomathematical Model of Fatigue for Predicting Individual Performance in Mild and Irregular Sleep Deprivation

Real-time Indicators and Influence Factors of Muscle Fatigue in Push-Type Work