Abstract:Abstract The limit of dynamic endurance during repetitive contractions has been referred to as the point of muscle fatigue, which can be measured by mechanical and electrophysiological parameters combined with subjective estimates of load tolerance for revealing the human real-world capacity required to work continuously. In this study, an isotonic muscular endurance (IME) testing protocol under a psychophysiological fatigue criterion was developed for measuring the retentive capacity of the power output of lower limb muscles. Additionally, to guide the development of electrophysiological evaluation methods, linear and non-linear techniques for creating surface electromyography (sEMG) models were compared in terms of their ability to estimate muscle fatigue. Forty healthy college-aged males performed three trials of an isometric peak torque test and one trial of an IME test for the plantar flexors and knee and hip extensors. Meanwhile, sEMG activity was recorded from the medial gastrocnemius, lateral gastrocnemius, vastus medialis, rectus femoris, vastus lateralis, gluteus maximus, and biceps femoris of the right leg muscles. Linear techniques (amplitude-based parameters, spectral parameters, and instantaneous frequency parameters) and non-linear techniques (a multi-layer perception neural network) were used to predict the time-dependent power output during dynamic contractions. Two mechanical manifestations of muscle fatigue were observed in the IME tests, including power output reduction between the beginning and end of the test and time-dependent progressive power loss. Compared with linear mapping (linear regression) alone or a combination of sEMG variables, non-linear mapping of power loss during dynamic contractions showed significantly higher signal-to-noise ratios and correlation coefficients between the actual and estimated power output. Muscular endurance required in real-world activities can be measured by considering the amount of work produced or the activity duration via the recommended IME testing protocol under a psychophysiological termination criterion. Non-linear mapping techniques provide more powerful mapping of power loss compared with linear mapping in the IME testing protocol.

Experimental Validation of a Subject-Specific Maximum Endurance Time Model.

A novel approach for determining fatigue resistances of different muscle groups in static cases

Muscular fatigue and maximum endurance time assessment for male and female industrial workers

Novel Approach to Estimate Endurance Limits in Intermittent Tasks

A new simple dynamic muscle fatigue model and its validation

Measurement of Subject-Specific Local Muscle Fatigability

Determination of subject-specific muscle fatigue rates under static fatiguing operations

The Relationship Between Ratings of Perceived Exertion (RPE) and Relative Strength for a Fatiguing Dynamic Upper Extremity Task: A Consideration of Multiple Cycles and Conditions.

A New Simple Local Muscle Recovery Model and Its Theoretical and Experimental Validation

Pulling strength, muscular fatigue, and prediction of maximum endurance time for simulated pulling tasks

Modeling of Maximum Endurance Time for Static Pulling Tasks.

Determining Endurance Limit Under Intermittent Physical Operations Based on a Combined Fatigue-Recovery Model.

Individualisation Method of Biomathematical Model of Fatigue for Predicting Individual Performance in Mild and Irregular Sleep Deprivation

Evaluation of Running Intensity and Fatigue Degree Based on Human Physiological Information

A Study on the Construction of Mental Fatigue Model and the Change of Psychological Efficacy

Translating Fatigue to Human Performance

Perceptions of fatigue and neuromuscular measures of performance fatigability during prolonged low-intensity elbow flexions

Subject-specific sensitivity of several biomechanical features to fatigue during an exhaustive treadmill run

Establishment and identification of an animal model of long-term exercise-induced fatigue

Retentive capacity of power output and linear versus non-linear mapping of power loss in the isotonic muscular endurance test

Electromyography-driven musculoskeletal models with time-varying fatigue dynamics improve lumbosacral joint moments during lifting