Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Catalytic Oxidation and Reaction Kinetics of Low Concentration Benzene over CuxMnyOz/SiO2

Catalytic Ozonation of Multiple Vocs at Low Temperature over a Potassium-Modified Mnox-Based Catalyst

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Experimental study of volatile organic compounds catalytic combustion on Cu‐Mn catalysts with different carriers

Mofs-derived CuCeOx Supported on H-zeolite Socony Mobile-5 for Catalytic Oxidation of 1,2-Dichlorobenzene

Low-Temperature Combustion of Toluene over Cu-Doped SmMn<sub>2</sub>O<sub>5</sub> Mullite Catalysts via Creating Highly Active Cu<SUP>2+</SUP>-O-Mn<SUP>4+</SUP> Sites

Catalytic oxidation of benzene over alumina-supported Cu-Mn-Ce mixed oxide catalysts

Low-temperature catalytic combustion of benzene over Zr–Mn mixed oxides synthesized by redox-precipitation method

Oxygen-dependent catalytic activity of mesoporous MnCO 3 -based catalysts for highly effective benzene oxidation

Ozone-catalytic Oxidation of Gaseous Benzene over MnO2/ZSM-5 at Ambient Temperature: Catalytic Deactivation and Its Suppression

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

Specific roles of lattice oxygen and asymmetric interface Cu-[O x ]-Ce structure-relating chemisorbed oxygen over CuO/CeO 2 on the catalysis of benzene combustion

Low-Temperature Benzene Abatement over Active Manganese Oxides with Abundant Catalytic Sites

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Efficient MnOx/SiO2@AC Catalyst for Ozone-Catalytic Oxidation of Gaseous Benzene at Ambient Temperature

Influences of different surface oxygen species on oxidation of toluene and/or benzene and their reaction pathways over Cu-Mn metal oxides

Mechanistic insights into benzene oxidation over CuMn2O4 catalyst

Catalytic Decomposition Of Benzene On Supported Nanometer Noble Metal Catalysts

CuMnAl–O Catalyst Synthesized via Pyrolysis of a Layered Double Hydroxide Precursor Attains Enhanced Performance for Benzene Combustion

Significant Enhanced SO 2 Resistance of Pt/SiO 2 Catalysts by Building the Ultrathin Metal Oxide Shell for Benzene Catalytic Combustion

Coupling effect of reaction conditions on the catalytic activity of Cu–Mn composite oxide catalysts for toluene