Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Catalytic Decomposition Of Benzene On Supported Nanometer Noble Metal Catalysts

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Catalytic Oxidation of Benzene over Atomic Active Site AgNi/BCN Catalysts at Room Temperature

Low-temperature catalytic combustion of benzene over Ni–Mn/CeO 2 /cordierite catalysts

Catalytic Degradation of Benzene over Nanocatalysts containing Cerium and Manganese

Decomposition of Trace Chlorobenzene over V2O5-WO3/TiO2-based Catalysts in Simulated Flue Gas

Effective Low‐temperature Catalytic Abatement of Benzene over Porous Mn‐Ni Composite Oxides Synthesized Via the Oxalate Route

Benzene abatement catalyzed by Ceria-Supported platinum nanoparticles and single atoms

Catalytic oxidation of benzene over alumina-supported Cu-Mn-Ce mixed oxide catalysts

Catalytic Decomposition of 1,2-Dichlorobenzene over V2O5/TiO2 Catalysts Blending with Typical Carbon Nanotubes

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

Catalytic Steam Reforming of Benzene as a Bio-tar Model Compound over Ni–Fe/TiO 2 Catalysts

Gaseous Benzene Photodegradation with Supported Nanosized TiO2

Generalized and High Temperature Synthesis of a Series of Crystalline Mesoporous Metal Oxides Based Nanocomposites with Enhanced Catalytic Activities for Benzene Combustion

Catalytic removal of gaseous benzene over Pt/SBA-15 catalyst: the effect of the preparation method

Catalytic Removal of Benzene at Mild Temperature over Manganese Oxide Catalysts

Improving Benzene Catalytic Oxidation on Ag/Co3O4 by Regulating the Chemical States of Co and Ag

Low-Temperature Benzene Abatement over Active Manganese Oxides with Abundant Catalytic Sites

Novel Photothermocatalytic Synergetic Effect Leads to High Catalytic Activity and Excellent Durability of Anatase TiO2 Nanosheets with Dominant {001} Facets for Benzene Abatement

Catalytic Degradation of Benzene over Non-Thermal Plasma Coupled Co-Ni Binary Metal Oxide Nanosheet Catalysts