Abstract:Purpose For moderate pressure and high pressure gear pumps, the temperature failure problem of bearings is now of considerable concern because of their heavy loads. However, the compact structure and the efficiency consideration make it extremely difficult to improve the bearing cooling. A self-circulating oil bearing system is developed for gear pumps with self-lubricating bearings to solve this problem. The oil is aspirated in from the low pressure chamber of the gear pump and discharged to the same chamber by using the pressure difference in the journal bearing, thus achieving the self-circulation. Design/methodology/approach An experiment test rig has been built for the feasibility study. The oil flow rate under different speeds has been recorded. Furthermore, the temperatures of the bearings with or without the oil circulation have been compared. Additionally, the oil flow in the test rig has been simulated using computational fluid dynamics codes. Findings The experimental and numerical results agree well. The experimental results indicate that the oil flow rate increases approximately linearly with the speed and the bearing temperature can be lowered successfully. The calculation results indicate that the bearing load capacity is nearly the same. Both the experimental and numerical studies establish that the self-circulating oil bearing system works successfully. Originality value As far as the authors know, it is the first time to find that the self-circulation can be built using the pressure difference in the bearing oil film, and this principle can be applied in the cooling and lubrication of the gear pumps to solve the temperature failure problem.

A Lubricant Flow Distribution Characteristic Analysis of a Wind Power Gearbox

Simulation Analysis for Lubrication State of the Thrust Washer Within Straight Planetary Gear Set

Numerical Analysis of Lubrication Property for Port Plate Pair of Axial Piston Pump

Dynamics characteristics of wind turbine gear pairs considering lubrication and tooth surface roughness

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Study on Mixed Lubrication Property of Planetary Gear Journal Bearing in Wind Turbine Gearbox

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Full-size experimental investigations on planetary gear journal bearings in high-power wind turbines

Review of Wind Power Bearing Wear Analysis and Intelligent Lubrication Method Research

Lubrication and stability analysis of nonlinear rotor-bearing system

Dynamic modeling and analysis of load sharing characteristics of wind turbine gearbox

Numerical analysis of the lubricating gap between the gear shaft and the journal bearing in water hydraulic internal gear pumps

Numerical Calculation Analysis and Characteristic Research on Windage Loss of Oil-Jet Lubricated Aviation Gear Pair

Optimization Design of Lubrication Performance of Planetary Gear Transmission

Plain Bearing Lubrication in Wind Turbine Gearboxes

Numerical and Experimental Investigation of Splashing Oil Flow in a Hypoid Gearbox

Tribo-dynamics Modeling and Analysis of Planetary Gear Bearing Systems in Wind Turbines Considering Sun-Planetary-ring Helical Gear Mesh and Elastic Deformation Effects

Analysis on Oil Film of Hydrostatic Bearing in Gear Pump Operating at High Pressures and High Speeds

Lubrication Model and Dynamic Characteristics of Distributed Liquid Film for Hydrodynamic Bearing

Nonlinear dynamic characteristics of wind power concentric planetary-face gear system with elastic lubrication and friction considering thermal effect under random wind load

Effect of meshing-induced deformation on lubrication for journal planet gear bearings