Plain Bearing Lubrication in Wind Turbine Gearboxes

Dirk Leimann

Abstract:Current wind turbine gearbox designs – in the power range from 2 up to 8 MW – typically consist of a combination of at least one planetary stage with at least one high speed helical gear stage. The majority of state-of-the-art designs are equipped with roller bearings. In the search for reliable solutions that are less prone to the specific failure mechanisms white etching crack WEC, the question arises whether plain bearings could be an alternative to the roller bearings. This paper presents the results from a gearbox development project of a 2 MW wind turbine gearbox with one planetary stage and 2 helical stages, in which roller bearings were substituted by plain bearings for all positions and that was tested on a test bench with respect to the most harmful operating conditions for plain bearings as starts and stops and idling. To ensure a reliable solution, insight is needed in relevant potential failure modes for plain bearings with respect to the lubrication on all positions. These potential failure modes need to be avoided by proper design rules that are relevant for the entire lifetime of a wind turbine gearbox (20 years) and validated with test procedures or measurements that are relevant to each risk. The result of the extensive testing was very promising so that the next step can be done to test on tower.

Materials Science,Computer Science,Engineering,Environmental Science