Abstract:Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, Ahead of Print. Due to the deep stage of oxygen, the pulverized coal cannot be burned completely in the primary combustion zone, resulting in a high content of residual carbon. The residual carbon in ash has a potential effect on the melting characteristics of ash, while there is a lack of specific research on the effects of residual carbon on ash fusion characteristics of high-alkali coals. In the present study, synthetic ash was blended with residual carbon to study the impacts of residual carbon content, graphitization level of the carbon, and atmospheric condition on ash fusion characteristics. Thermogravimetric analyzers and ash melting point testers were used to study the thermogravimetric behavior of ash and the characteristic temperatures of ash fusion, and then analyze the changes in the mineral composition and micromorphology of slag using X-ray diffractometers and scanning electron microscopy. The experimental results reveal that the change in residual char content exerts a minor influence on the type of crystalline minerals within the ash, while it affects the relative content of various minerals. The softening temperature of the ash blended with activated carbon and graphite are 1234°C and 1242°C, respectively. The blending of activated carbon greatly promotes the generation of gehlenite (Ca2Al2SiO7, 1593°C) and inhibits the generation of merwinite (Ca3MgSi2O8, 1550°C), increasing the ash melting temperature. The ash fusion characteristic temperatures of the pure synthetic ash decrease with the enhancement of the reductive atmosphere. However, the ash fusion characteristic temperatures of the ash blended with carbon in strong reducing atmosphere are increased compared to those in weak reducing atmosphere because part of the carbon acts as a skeleton or reacts to form a carbon-silicon compound. The present study can offer improved knowledge to provide fundamental support for the combustion and utilization of high-alkali Zhundong coal under deep oxygen-staged conditions.

Effects Of Temperature And Additives On Ash Transformation And Melting Of High-Alkali-Chlorine Coal

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Effects of Sodium Carbonate and Sodium Chloride Additives on Alkaline Fusion of Coal Fly Ash

Investigation on Release and Migration Characteristics of Sodium During the Combustion of High-Sodium Coal with Phosphorite

12th International Conference on Fluidized Bed Technology EFFECT OF ADDITIVES ON THE ASH FUSION TEMPERATURE

Effect of additives on flow characteristics and sodium capture efficiency of high alkali coal ash slag

Effect of different additives on ash fusion characteristic and mineral phase transformation of iron-rich Zhundong coal

The Desulfurization Behavior of Mineral Matter in Ash During Coal Combustion at High Temperature

Slagging behavior and mechanism of high-sodium–chlorine coal combustion in a full-scale circulating fluidized bed boiler

Effect of Five Different Additives on the Sintering Behavior of Coal Ash Rich in Sodium under an Oxy-Fuel Combustion Atmosphere

Influence of Sodium-Based Compound on Ash Melting Characteristics of High Alkali Coal

Influence of kaolin on sodium retention and ash fusion characteristic during combustion of Zhundong coal

Study on the Coal Ash Fusibility During Blending Coal Combusition

Regulation Mechanism of Ash Fusion of Iron‐Rich Coal in Xinjiang with Different Additives

Effect of Chlorine, Sulfur, Moisture and Ash Content on the Partitioning of As, Cr, Cu, Mn, Ni and Pb During Bituminous Coal and Pickling Sludge Co-Combustion

Improvement of the Coal Ash Slagging Tendency by Coal Washing and Additive Blending with Mullite Generation

The effects of additives on deposit formation during co-firing of high-sodium coal with high-potassium and -chlorine biomass

Investigation on the influence of sulfur and chlorine on the initial deposition/fouling characteristics of a high-alkali coal

Mineral Conversion of Coal-ash in Fusing Process and the Influence to Ash Fusion Point

Experimental study on the effects of residual carbon on ash fusion characteristics of high-alkali Zhundong coal under deep oxygen-staged condition