Abstract:Polymers of intrinsic microporosity (PIMs) are a promising membrane material for gas separation, because of their high free volume and micro-cavity size distribution. This is countered by PIMs-based membranes being highly susceptible to physical aging, which dramatically reduces their permselectivity over extended periods of time. Supercritical carbon dioxide is known to plasticize and partially solubilise polymers, altering the underlying membrane morphology, and hence impacting the gas separation properties. This investigation reports on the change in PIM-1 membranes after being exposed to supercritical CO2 for two- and eight-hour intervals, followed by two depressurization protocols, a rapid depressurization and a slow depressurization. The exposure times enables the impact contact time with supercritical CO2 has on the membrane morphology to be investigated, as well as the subsequent depressurization event. The density of the post supercritical CO2 exposed membranes, irrespective of exposure time and depressurization, were greater than the untreated membrane. This indicated that supercritical CO2 had solubilised the polymer chain, enabling PIM-1 to rearrange and contract the free volume micro-cavities present. As a consequence, the permeabilities of He, CH4, O2 and CO2 were all reduced for the supercritical CO2-treated membranes compared to the original membrane, while N2 permeability remained unchanged. Importantly, the physical aging properties of the supercritical CO2-treated membranes altered, with only minor reductions in N2, CH4 and O2 permeabilities observed over extended periods of time. In contrast, He and CO2 permeabilities experienced similar physical aging in the supercritical treated membranes to that of the original membrane. This was interpreted as the supercritical CO2 treatment enabling micro-cavity contraction to favour the smaller CO2 molecule, due to size exclusion of the larger N2, CH4 and O2 molecules. Therefore, physical aging of the treated membranes only had minor impact on N2, CH4 and O2 permeability; while the smaller He and CO2 gases experience greater permeability loss. This result implies that supercritical CO2 exposure has potential to limit physical aging performance loss in PIM-1 based membranes for O2/N2 separation.

Controlled Superacid-Catalyzed Self-Cross-Linked Polymer of Intrinsic Microporosity for High-Performance CO2 Separation

Molecular‐Sieving Membrane by Partitioning the Channels in Ultrafiltration Membrane by in Situ Polymerization

Post-modification of PIM-1 and simultaneously in situ synthesis of porous polymer networks into PIM-1 matrix to enhance CO2 separation performance

Surface functionalization of Polymers of Intrinsic Microporosity (PIMs) membrane by polyphenol for efficient CO2 separation

Ester-crosslinked Polymers of Intrinsic Microporosity Membranes with Enhanced Plasticization Resistance for CO2 Separation

Post‐synthesis Amination of Polymer of Intrinsic Microporosity Membranes for CO2 Separation

Crosslinked Microporous Membrane with Pore Compensation for Efficient and Long-Term Gas Separation

Enhanced CO2 Selectivities by Incorporating CO2-philic PEG-POSS into Polymers of Intrinsic Microporosity Membrane

Bis(phenyl)fluorene-based polymer of intrinsic microporosity/functionalized multi-walled carbon nanotubes mixed matrix membranes for enhanced CO<sub>2</sub> separation performance

Intermediate Thermal Manipulation of Polymers of Intrinsic Microporous (pims) Membranes for Gas Separations

Super high gas separation performance membranes derived from a brominated alternative PIM by thermal induced crosslinking and carbonization at low temperature

Tartaric Acid Anion Intercalated Layered Double Hydroxides Constructed a CO2-favorable Transport Channel in PIM-1 Mixed Matrix Membranes for CO2/N2 Separation

The Researches on Polymers of Intrinsic Microporosity Membranes for Separation

Polymers of Intrinsic Microporosity Having Bulky Substitutes and Cross-Linking for Gas Separation Membranes

Mixed Matrix Membranes Comprising Polymers of Intrinsic Microporosity and Covalent Organic Framework for Gas Separation

Bis(phenyl)fluorene-based polymer of intrinsic microporosity/functionalized multi-walled carbon nanotubes mixed matrix membranes for enhanced CO2 separation performance

In Situ Hydrolyzed Microporous Polymer Membranes for Additional Free Volume to Facilitate CO2 Permeation

Decarboxylation-Induced Cross-Linking of Polymers of Intrinsic Microporosity (pims) for Membrane Gas Separation

Metal‐Coordinated, Dual‐Crosslinked PIM Polymer Membranes for Upgraded CO2 Separation: Aging and Plasticization Resistance

In-situ crosslinking of a novel conjugated dialkynyl-based polyimide for high performance carbon molecular sieve membrane

Polymer of Intrinsic Microporosity (PIM-1) Membranes Treated with Supercritical CO2