Abstract:Spontaneous condensation of gas at transonic or supersonic flow is a great concerned phenomenon in many cryogenic engineering fields. An accurate model is of great significance to better understand the mechanism of such condensation and arising issues. In this paper, numerical studies for the effect of droplet growth model modification on the nitrogen condensation flow through Laval nozzles were performed in ANSYS CFX via user defined language. The used four profiles of Laval nozzle were designed with different expansion rate (3000, 5000, 7000 and 10000 s(-1)) in Ji's experiment (Ji 1990). The throat size is 6.5 (height) x 3.2 (width) mm. Firstly, the classical nucleation model with non-isothermal correction was successful to accurately predict the location of condensation onset in experiment by the down calibration for nucleation rate. The supercooled degree is about 9K and nucleation rate is at the order of 10(20) m(-3).s(-1). Secondly, the simulations of condensation flow using different droplet growth models including Gyarmathy and Young models were accomplished. Based on the analysis of interphase heat and mass transfer, the influence mechanism caused by modification for droplet growth rate on two-phase flow fields was revealed. The results indicate that this modification has a considerable effect on the development of droplet size and relaxation time of gas back to equilibrium, but little influence on location prediction of condensation onset. Finally, the effect of inlet total pressure on two-phase flow parameters was also analyzed. At low pressure, a larger supercooled degree (similar to 11 K) is required to trigger the occurrence of spontaneous condensation. Correspondingly, the influence intensity resulting from the change of droplet growth model on the interphase mass transfer and thermal fields will obtain some enhancement, but still inappreciable compare to the expansion effect. (C) 2019 Elsevier Ltd. All rights reserved.

Numerical Investigation of Nitrogen Condensation Flow over Airfoil in Cryogenic Wind Tunnel

Numerical investigation of the operating conditions affecting nitrogen condensation on a three-dimensional wing in the cryogenic wind tunnel

Numerical Analysis of Nitrogen Condensation Heat Transfer Enhancement with Liquid Film Fluctuation at Cryogenic Temperature

Numerical investigation on the tracer followability of nitrogen droplets over the airfoil in cryogenic wind tunnel

Numerical Simulation of Trace Water Icing Characteristics on Airfoil Under Cryogenic Conditions

Experimental Investigation on Flow Condensation Heat Transfer and Pressure Drop of Nitrogen in Horizontal Tubes

Characteristic Analysis of Fluctuating Liquid Film Flow Behavior and Heat Transfer in Nitrogen Condensation

Numerical Investigation of Moist Air Flow with Non-equilibrium Condensation Around Airfoils

Numerical Studies of Nitrogen Spontaneous Condensation Flow in Laval Nozzles Using Varying Droplet Growth Models

Numerical investigation of nitrogen spontaneous condensation flow in cryogenic nozzles using varying nucleation theories

Experimental Study on Film Condensation Characteristics at Liquid Nitrogen Temperatures

Numerical Study of Liquid Nitrogen Cavitating Flow Through Nozzles of Various Shapes

Numerical Simulation of Liquid Nitrogen Around Hydrofoil Cryogenic Cavitation

Numerical Simulation of Equilibrium Condensation Two-Phase Flow in Cryogenic Turboexpander

Three-dimensional Numerical Simulation of Cryogenic Cavitating Flows of Liquid Nitrogen Around Hydrofoil

Numerical Studies on Two-Phase Flow in Cryogenic Radial-Inflow Turbo-Expander Using Varying Condensation Models

Unsteady Cavitation of Liquid Nitrogen Flow in Spray Nozzles under Fluctuating Conditions

Mechanisms of Trace Water Vapor Desublimation over Airfoil in Transonic Cryogenic Wind Tunnels

Cooling Performance of Multi-Nozzle Spray with Liquid Nitrogen

Numerical investigation on the impact of injection rates on cooling performance in a rotor-stator cavity with liquid nitrogen spraying

Numerical Study on the Spontaneous Condensation Flow in an Air Cryogenic Turbo-Expander Using Equilibrium and Non-Equilibrium Models