Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. Heat affected zone on the micromachined material, a hindrance in achieving good precision and accuracy, which are adequate requirements for micromachined materials, is a drawback of nanosecond micromachining assisted by laser. The primary objective of this paper is to take into consideration a number of input parameters, such as the pulse width and the temperature of the laser beam, and study the effect that these parameters have on the heat flux generated as well as on the temperature distribution along the square grooves of 200 μm width and depth that are to be micro-machined on an alumina ceramic workpiece. However, processing of alumina ceramic on a micron-scale requires careful consideration to raise the quality standard. This will be accomplished by analyzing the data collected from the micro-machining process. Using the ANSYS® software, it is possible to visualize not only the region where heat is generated but also the way in which the input parameters influence the structural qualities of the micro machined groove surface. The many thermal models that have been constructed have revealed specific changes in the structural qualities that have had a significant impact on the upper width, the lower width, and the depth of the groove when applied to a variety of different parametric settings. Finally, developed analytical model is compared with the experimental models. The highest prediction error was found to be 1.68%, while, for constant 50 W power and 150–250 mm/s of speed, the average prediction error was determined to be 1.18%. As a result, the proposed model closely matches the experimental findings, and the proposed model can be used to estimate channel profile.

Micromachining Porous Alumina Ceramic for High Quality Trimming of Turbine Blade Cores Via Double Femtosecond Laser Scanning

Trimming for Alumina-Based Ceramic Casting Cores for Turbine Blade by Double Picosecond Laser Scanning

Picosecond laser trimming of ceramic cores with porous multi-scale particle microstructure

A zone-layered trimming method for ceramic core of aero-engine blade based on an advanced reconfigurable laser processing system

Investigation on Geometric Precision and Surface Quality of Microholes Machined by Ultrafast Laser

Laser Ablation Study of Cutting Ceramics with Consideration of the Beam Inclination Angle

Alumina-based ceramic mold with integral core and shell for hollow turbine blades fabricated by Laser powder bed fusion

Study of the dynamics of material removal processes in combined pulse laser drilling of alumina ceramic

Theoretical and Experimental Investigation on Inclined Ultrasonic Elliptical Vibration Cutting of Alumina Ceramics

Triple Rings Trepanning Technology for Holes Ablated Using Nanosecond Pulse Laser in Al2O3 Ceramics Substrate

Water Jet Guided Laser Grooving of Sicf/Sic Ceramic Matrix Composites

Fabrication and Characterization of Micro-Channels on Al2O3/TiC Ceramic Produced by Nanosecond Laser

Performance of silicon oxide-based ceramic cores made by rapid prototyping for single crystal turbine blades

Laser drilling of alumina ceramic substrates: A review

Ablation characteristics of femtosecond laser on wide band-gap ceramics

Computational approach for structural and thermal behavior of laser-machined micro-grooves on alumina ceramic using ANSYS

Rapid fabrication of alumina-based ceramic cores for gas turbine blades by stereolithography and gelcasting

Trepanning of Supper-Alloy with Thermal Barrier Coating Using Femtosecond Laser

Additive manufacturing of Al2O3 ceramic core with applicable microstructure and mechanical properties via digital light processing of high solid loading slurry

Optimization of Trepanning Patterns for Holes Ablated Using Nanosecond Pulse Laser in Al2O3 Ceramics Substrate

Microstructure and mechanical properties of 3D-printed nano-silica reinforced alumina cores