Abstract:Waterjet-assisted laser drilling technology facilitates the fabrication of high-quality micro-holes by utilizing the collaborative benefits of waterjets and lasers. In this study, the coaxial waterjet-assisted laser drilling (CWALD) technique was employed to improve the properties of micro-holes during femtosecond laser drilling. Based on computational fluid dynamics (CFD) simulations, the stability of the waterjet was initially verified by optimizing the structure of the watercourse and nozzle shape in the CWALD device. Furthermore, a comparative experiment between laser direct drilling (LDD) and CWALD revealed that while CWALD can produce well-rounded micro-holes with a high aspect ratio, it exhibits lower efficiency and results in a larger heat-affected zone (HAZ). To address these drawbacks associated with CWALD, a two-step coaxial waterjet-assisted composite laser drilling (TS-CWALD) method was proposed. TS-CWALD involves applying CWALD for secondary modification of micro-hole shape following LDD with punching. This modification process is pivotal for enhancing drilling accuracy but requires consideration of multiple parameters. For this purpose, regression models were established for the inlet diameter, outlet diameter, and taper; response surface methodology was then employed to optimize these parameters. Subsequently, interactive effects analysis was conducted on different responses based on laser pulse energy, frequency, modification speed, and number of modification cycles. The adequacy of the developed models was subsequently verified using analysis of variance methods. Finally, the successful fabrication of a film hole with an inlet diameter of 205 μm and an outlet diameter of 200 μm, featuring a taper of only 0.2°, was achieved ultimately through meticulous parameter optimization. Furthermore, the micro-hole retained a minimal HAZ. The optimized parameters encompassed a pulse energy of 20.6 μJ, frequency of 127 kHz, modification speed of 3 mm/s, and shape modification carried out over 335 cycles.

Picosecond laser trimming of ceramic cores with porous multi-scale particle microstructure

A zone-layered trimming method for ceramic core of aero-engine blade based on an advanced reconfigurable laser processing system

Temperature field simulation and optimization of processing parameters for laser-assisted machining of 3Y-TZP ceramics

POLYMER-DERIVED SIC CERAMIC WITH TRIPLY PERIOD MINIMAL SURFACE STRUCTURE FABRICATION THROUGH DIGITAL LIGHT PROCESSING

Microstructure and properties evolution of silicon-based ceramic cores fabricated by 3D printing with stair-stepping effect control

Automatic Pico Laser Trimming System for Silicon MEMS Resonant Devices Based on Image Recognition

Advances in Laser Drilling of Structural Ceramics

An experimental investigation of scan trajectory into the underwater femtosecond laser polishing SiC ceramic

Post-Processing Trimming of Silicon Photonic Devices Using Femtosecond Laser.

Triple Rings Trepanning Technology for Holes Ablated Using Nanosecond Pulse Laser in Al2O3 Ceramics Substrate

Water jet guided laser grooving of SiC f /SiC ceramic matrix composites

Research on hole depth in femtosecond laser deep micropore processing technology based on filament effect

A study of laser machining combined with dynamic chemical etching in micro‐hole drilling of 2.5D SiCf/SiC composites

Experimental investigation and optimization of modification during coaxial waterjet-assisted femtosecond laser drilling

Laser Ablation Study of Cutting Ceramics with Consideration of the Beam Inclination Angle

Dual-Method Characterization and Optimization of Drilling Parameters for Picosecond Laser Drilling Quality in CFRP

An on-machine tool path generation method based on hybrid and local point cloud registration for laser deburring of ceramic cores

New approach to preparing near zero shrinkage alumina ceramic cores with excellent properties by vat photopolymerization

Microstructure evolution and ablation mechanism of SiCf/SiC ceramic matrix composite microgrooves processed by pico-second laser

Fabrication of high-performance silica-based ceramic cores through selective laser sintering combined with vacuum infiltration

Influence of debinding parameter and nano-ZrO2 particles on the silica-based ceramic cores fabricated by stereolithography-based additive manufacturing