Abstract:The effectiveness of in-vessel retention (IVR) of core melt during severe accident in light water reactor strongly depends on whether the heat removed from boundaries could exceed the heat generated in the molten pool in lower head of reactor pressure vessel (RPV). Natural convection in the oxidic pool plays a key role in determining the heat transfer behavior inside the molten pool. A Molten pool Oxide-layer heat tRaNsfer experiment (MORN) facility was built to investigate the heat transfer characteristic of the molten oxidic pool with the intention to verify the heat transfer correlation of the pool. The test facility consists of a three dimensional hemisphere test section with an inner radius of 0.4 m. The outer boundary of the test section could be cooled by different methods (radiation or convection), so as to study the influence of external cooling condition on the crust formation of oxidic pool. Three kinds of material have been chosen as the simulants. They are water, NaNO3/ENO3(mole ratio 1:4) and a non-eutectic binary mixture of calcium-boron oxide (30 wt%CaO-70 wt% B2O3) respectively. At first period, several water and salt experiments with the melt height of 340 mm were performed and the data were analyzed. Though the normalized temperature distribution of the pool was nearly the same between water and salt experiments, the heat flux across the side wall differed much. The heat flux distribution of the water experiment rose nearly linearly with polar angle till to the melt surface. The heat flux of salt experiment at the low angle was larger than that of water, decreased slightly with angle increasing and then rose quickly till to the melt surface. This is consistent with the LIVE and COPRA experiments with the same boundary condition. The maximum normalized heat flux of the water experiment was approximate 1.6 and that of the salt experiment was about 2.2. The downward heat transfer of MORN is smaller than the correlation derived by COPO, mini-ACOPO and BALI experiments, but is consistent as LIVE, COPRA experiment.

Experimental Research on the Influence of Rolling Motions on the Convection Behaviors Inside Two-Layer Corium Pools

Heat transfer behaviors in corium pools under swinging conditions

In-Vessel Retention of Molten Core Debris for CAP1400

Analysis of coolant flow distribution characteristics at core inlet of small pressurized water reactor under rolling condition

CFD simulation of a full-scale three-dimensional flow and temperature distribution inside a reactor under ocean conditions

Simulation Model for Investigating Safety Margin of Three-Layer Molten Pool after Late Phase In-Vessel Water Injection

ICONE19-43276 Preliminary Study on In-Vessel Retention in Large-Scale Advanced PWR

Experimental Investigation on Heat Transfer Characteristics of Oxide Layer of Molten Pool

Study on the Calculation Method of Molten Pool Decay Heat Distribution under IVR Condition

Heat Transfer Experiment with the Prototypical Ra Number of Heavy Metallic Layer in IVR Strategy

Numerical Investigation on the Thermal-Hydraulic Characteristics near a Corroded Lower Head of the Reactor Vessel During IVR-ERVC

Experimental Investigation of Natural Circulation in A Symmetrical Loop under Large Scale Rolling Motion Conditions

Research on Uncertainty Analysis of In-Vessel Retention Parameters in Advanced PWR

Study on stable multi-layer molten pool experiment with internal heat generation in ERVC-IVR strategy

Three-dimensional Experiment of Heat Transfer for Molten Oxidic Pool

Theoretical Analysis of A Natural Circulation System under Rolling Condition Based on Relap5/Mod3.3 Code

Single Phase Natural Circulation Behaviors of the Integral Type Marine Reactor Simulator under Rolling Motion Condition

Experimental Research on Influence of Real Surface Material and Aging Effect on ERVC-CHF of RPV

Investigation on Three-Layer Coupled Molten Pool Heat Transfer Experiment with Three Different Materials

Simulation investigation of ocean motion on small reactor based on modified system code

Experimental Research of Heat Transfer in Heavy Metallic Layer under Different Top Boundary Conditions