Experimental Investigation of Natural Circulation in A Symmetrical Loop under Large Scale Rolling Motion Conditions

Hongye Zhu,Xingtuan Yang,Jiyuan Tu,Shengyao Jiang

DOI: https://doi.org/10.1080/00223131.2013.808969

IF: 1.126

2013-01-01

Journal of Nuclear Science and Technology

Abstract:In ocean environment, the ship motion significantly affects the natural circulation behavior in ship-based integrated-type reactor. This paper theoretically and experimentally investigated natural circulation characteristics in symmetrical loops under rolling condition. Experiments were carried out on a test loop with a symmetrical configuration by simulating the structure of an accrual reactor. The theoretical results revealed that only angular acceleration contributes to the resultant force under zero power rolling condition. In a closed circuit with a uniform cross-section area, the angular acceleration force integral is proportional to the angular acceleration and the area enclosed by the circuit. The integral value varies over time and causes flow oscillations. However, the angular acceleration force does not influence the flow status in the shared part of the two symmetrical neighbor circuits due to force interactions. Rolling experiments with a zero power load confirmed these results. Full power experiments under rolling condition exhibited observable flow rate and temperature oscillations in each branch of the flow channel. The oscillations in the side flow channels had the same values for both the period and the phase with the variation of rolling angle. The angular acceleration force was the main cause of this. The oscillations in the middle channel had a period half the value of the rolling period. The periodical variation of the vertical component of gravity caused this. The horizontal component of gravity was out-phasing with angular acceleration. Therefore, it alleviated oscillation in the side channels. The experimental results showed that for the same rolling period, as the rolling angle increased, the average flow rate decreased and oscillation amplitudes increased. Also, as the power load increased, the oscillations in the middle channel increased and the oscillation in the side channel decreased.