Abstract:Cracking of pavement materials affects the service performance of pavement structures. It is widely investigated by discrete element method (DEM) because the DEM can present the cracking behavior and mechanism from the mecroscopic perspective. However, improper calibration method is time-consuming and the simulation results are not applicable for different loading conditions. To address this issue, a systematical calibration method is proposed to establish a more reasonable DEM model, and it is used to explore the cracking behavior and mechanism for pavement materials. The fiber reinforced cement treated aggregates (F-CTA) used to construct the pavement base are selected as an example to elaborate the process. First, contacts within the F-CTA were divided into five groups according to physical components. Then, laboratory tests were performed to obtain macro mechanical properties including strength and modulus. Next, the corresponding virtual tests were established and the contact model parameters were calibrated from mono-component to mixture. This calibration method was validated by the three-point bending test incorporating all contact parameters obtained from the above calibrations and the process of cracking evolution was analyzed. Results show that the simulated mechanical responses and crack distribution based on the systematical calibration are in good agreement with laboratory measurements and observations, exhibiting well reliability for calibrating contact parameters of composite material. Young's modulus of the F-CTA is sensitive to the mecro effective modulus in the virtual indirect tensile test while Young's modulus and tensile strength are vulnerable to the mecro cohesion in the virtual uniaxial compression test. The mortar-aggregate and mortar-aggregate interface is relatively weak where cracks are prone to appear. The fibers can optimize the distribution of the crack network. The cracking evolution contains three stages and the second stage has a significant influence on the cracking behavior of the F-CTA.

Evaluation of Air Void and Cracking Characters of Cement-Stabilized Crushed Stone Through X-ray Computed Tomography

Stochastic Fracture of Concrete Composites: A Mesoscale Methodology

Hybrid Phase-Field Modeling of Mesoscopic Failure in Concrete Combined with Fourier-Voronoi Stochastic Aggregate Distribution Modelling Approach

Systematical Calibration and Validation of Discrete Element Models for Fiber Reinforced Cement Treated Aggregates

3D Digital Analysis of Cracking Behaviors of Rocks through 3D Reconstruction Model under Triaxial Compression

Study on the progressive fracturing in soil and rock mixture under uniaxial compression conditions by CT scanning

A New Graphical Quantitative Evaluation Method of Concrete Cracks Based on Digital Image Technology and Fractal Theory

Influence of Aggregates' Spatial Characteristics on Air-Voids in Asphalt Mixture

Effects of Moisture Content on the Cyclic Behavior of Crushed Tuff Aggregates by Large-Scale Tri-Axial Test

3D meso-scale fracture modelling and validation of concrete based on in-situ X-ray Computed Tomography images using damage plasticity model

Effects of Crack and Itz and Aggregate on Carbonation Penetration Based on 3d Micro X-Ray Ct Microstructure Evolution

Air voids distribution of asphalt mixtures in different compaction methods and aggregate gradations

The Classification and Mechanism of Microcrack Homogenization Research in Cement Concrete Based on X-ray CT

Initial Microcrack Characteristics of Concrete Interfacial Transition Zone and Cement Paste

Research Progress on Cement-Based Materials by X-ray Computed Tomography

Study on the Properties and Mechanisms of a Cement-Stabilized Aggregate Mixture with Vibration Mixing

Two-dimensional X-ray CT Image Based Meso-Scale Fracture Modelling of Concrete

Damage Evolution in Asphalt Mixtures Based on In-Situ CT Scanning

In-situ X-ray Computed Tomography Characterisation of 3D Fracture Evolution and Image-Based Numerical Homogenisation of Concrete

COMPUTED TOMOGRAPHY TECHNOLOGY FOR MICROSTRUCTURAL STUDYING ON CEMENT-BASED MATERIALS:A REVIEW ON THE STATE OF THE ART

Three-Dimensional in Situ XCT Characterisation and FE Modelling of Cracking in Concrete