Abstract:Shorter technology enable us to create higher speed oscillators which can provide better resolution in time domain. Therefore, a simple ADC using voltage (or current) controlled oscillator (VCO) and a counter can be implemented using this approach. Conceptually, the operation order in this ADC is similar to a conventional ΣΔ modulator. The CCO integrates frequency to produce output in the form of phase. And the number of stages in the CCO determines the quantization levels (or phase resolution). The difference of quantized phase output produces a frequency proportional to the input signal. Therefore, unlike, a conventional ΣΔ modulator no feedback is required for a first order noise shaping. In order to achieve a low power for moderate performance two key techniques have been used: a) a cross-coupled voltage to current (V/I) converter to achieve non-linearity cancellation (mainly 3rd-order harmonic), and b) a stack structure to share current between V/I converter and CCO to reduce power. This ADC has been simulated using models of typical 130nm CMOS technology. In SPICE simulation, SQDR/SFDR of 67.5 dB/71 dB is achieved over a total signal bandwidth of 5 MHz for an input swing of 300mV (Vpp) for typical corner at room temperature. The analog blocks consumed a total of 96.5μW from a regulated 1.2V supply, whereas, the digital blocks consumed an estimated power of 1.1 mW. Since, the major circuit blocks are digital in nature, the presented circuit is highly amenable with technology scaling.

A 18.5-fJ/step VCO-Based 0-1 MASH Delta Sigma ADC with Digital Background Calibration Arindam Sanyal and Nan Sun

A 18.5-fJ/step VCO-based 0–1 MASH ΔΣ ADC with digital background calibration

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 12-B ENOB 2.5-Mhz BW VCO-Based 0-1 MASH ADC with Direct Digital Background Calibration

A 12b ENOB, 2.5Mhz-Bw, 4.8mw VCO-based 0&#x2013;1 MASH ADC with Direct Digital Background Nonlinearity Calibration

A 14-bit 500MS/s and 1GS/s Configurable Pipelined ADC with Background Calibration

A Sub-1μW 16-Bit Fully Dynamic Zoom ADC Compatible with Free-running and Incremental Modes Using Residue Feedforward and Extended Counting Techniques

A 0.04-Mm2 0.9-Mw 71-Db SNDR Distributed Modular AS ADC with VCO-based Integrator and Digital DAC Calibration

A 1.2-V 2.87-Μ W 94.0-Db SNDR Discrete-Time 2–0 MASH Delta-Sigma ADC

A Scaling-Friendly Low-Power Small-Area <formula Formulatype="inline"><tex Notation="TeX">$\Delta\Sigma$</tex></formula> ADC with VCO-Based Integrator and Intrinsic Mismatch Shaping Capability

A Hybrid Sar-Vco Delta Sigma Adc With First-Order Noise Shaping

Highly Linear Continuous-Time MASH ΔΣ ADC with Dual VCO-based Quantizers

A 3.5 GS/s 1-1 MASH VCO ADC With Second-Order Noise Shaping

A 1.8mW 2MHz-BW 66.5dB-SNDR ΔΣ ADC using VCO-based integrators with intrinsic CLA

An 81.5Db-Dr 1.25Mhz-Bw VCO-Based CT ΔΣ ADC with Double-PFD Quantizer

A hybrid SAR-VCO ΔΣ ADC with first-order noise shaping

A 1.2 mW 67.5 dB SQDR VCO-based ΣΔ ADC with Non-linearity Cancellation Technique

A Closed-Loop VCO-based 1-1 SMASH CT ΔΣ ADC Architecture

A 7-bit 900-MS/s 2-Then-3-bit/cycle SAR ADC With Background Offset Calibration

A 55fJ/conv-step hybrid SAR-VCO ΔΣ capacitance-to-digital converter in 40nm CMOS

Highly Linear Continuous-Time Mash Delta Sigma Adc With Dual Vco-Based Quantizers