Abstract:The thermo-chemical conversion of biomass wastes is a practical approach for the value-added reclamation of bioenergy in large quantities, and pyrolysis plays a core role in this process. In this work, poplar (PR) and cedar (CR) were used as staple wood biomasses to investigate the apparent kinetics of TG/DTG at different heating rates. Secondly, miscellaneous wood chips (MWC), in which PR and CR were mixed in equal proportion, were subjected to comprehensive investigations on their pyrolysis behavior and product evolution in a fixed bed reactor with pyrolysis temperature, catalyst, and the flow rate H2O steam as influencing factors. The results demonstrated that both PR and CR underwent three consecutive pyrolysis stages, the TG/DTG curves shifted to higher temperatures, and the peak temperature intervals also enhanced as the heating rate increased. The kinetic compensation effect expression and apparent reaction kinetic model of CR and PR pyrolysis were obtained based on the law of mass action and the Arrhenius equation; the reaction kinetic parameter averages of Ea and A of its were almost the same, which were about 72.38 kJ/mol and 72.36 kJ/mol and 1147.11 min−1 and 1144.39 min−1, respectively. The high temperature was beneficial for the promotion of the pyrolysis of biomass, increased pyrolysis gas yield, and reduced tar yield. This process was strengthened in the presence of the catalyst, thus significantly increasing the yield of hydrogen-rich gas to 117.9 mL/g-biomass. It was observed that H2O steam was the most effective activator for providing a hydrogen source for the whole reaction process, promoted the reaction to proceed in the opposite direction of H2O steam participation, and was beneficial to the production of H2 and other hydrocarbons. In particular, when the flow rate of H2O steam was 1 mL/min, the gas yield and hydrogen conversion were 76.94% and 15.90%, and the H2/CO was 2.07. The yields of H2, CO, and CO2 in the gas formation were significantly increased to 107.35 mL/g-biomass, 53.70 mL/g-biomass, and 99.31 mL/g-biomass, respectively. Therefore, H2 was the most dominant species among gas products, followed by C-O bond-containing species, which provides a method for the production of hydrogen-rich gas and also provides ideas for compensating or partially replacing the fossil raw material for hydrogen production.

From Douglas fir to renewable H-2-enriched syngas via ex situ catalytic pyrolysis over metal nanoparticles-nanocellulose derived carbon catalysts

From Douglas fir to renewable H<sub>2</sub>-enriched syngas <i>via ex situ</i> catalytic pyrolysis over metal nanoparticles–nanocellulose derived carbon catalysts

Bimetal-modified G-C3n4 Photocatalyst for Promoting Hydrogen Production Coupled with Selective Oxidation of Biomass Derivative

Pyrolyzing Renewable Sugar and Taurine on the Surface of Multi-Walled Carbon Nanotubes As Heterogeneous Catalysts for Hydroxymethylfurfural Production

Catalytic fast co-pyrolysis of Douglas Fir and low-density polyethylene with nanocellulose-derived carbon catalyst for enhancing selectivity of hydrogen in syngas and mono-aromatic hydrocarbon in bio-oil products

Hydrogen-rich syngas production from biomass gasification using biochar-based nanocatalysts

A Study on the Pyrolysis Behavior and Product Evolution of Typical Wood Biomass to Hydrogen-Rich Gas Catalyzed by the Ni-Fe/HZSM-5 Catalyst

Catalytic pyrolysis of biomass with Ni/Fe-CaO-based catalysts for hydrogen-rich gas: DFT and experimental study

Enhanced Hydrogen Production by the Catalytic Alkaline Thermal Gasification of Cellulose with Ni/Fe Dual-Functional CaO Based Catalysts

High-purity syngas production by cascaded catalytic reforming of biomass pyrolysis vapors

Hydrogen-rich syngas production from biomass pyrolysis and catalytic reforming using biochar-based catalysts

Enhanced Selectivity in the Production of Furans/Olefins through Ex-situ Catalytic Pyrolysis over Metal-Modified TS-1

Enhancing ketones and syngas production by CO2-assisted catalytic pyrolysis of cellulose with the Ce–Co–Na ternary catalyst

Enhancing syngas production and hydrogen content in syngas from catalytic slow pyrolysis of biomass in a pilot scale fixed bed reactor

Nitrogen-doped ordered mesoporous carbon supported ruthenium metallic nanoparticles: Opportunity for efficient hydrogenolysis of biomass-derived 5-hydroxymethylfurfural to 2,5-dimethylfuran by catalytic transfer hydrogenation

H2 Production from Co-Pyrolysis/gasification of Waste Plastics and Biomass under Novel Catalyst Ni-CaO-C

Production of H2-Rich Syngas From Lignocellulosic Biomass Using Microwave-Assisted Pyrolysis Coupled With Activated Carbon Enabled Reforming

Catalytic pyrolysis of rice husk to co-produce hydrogen-rich syngas, phenol-rich bio-oil and nanostructured porous carbon

Insight into the Ex Situ Catalytic Pyrolysis of Biomass over Char Supported Metals Catalyst: Syngas Production and Tar Decomposition

Insight into the Mechanism of 5-Hydroxymethylfurfural Electroreduction to 2,5-Bis(hydroxymethyl)furan over Cu Anchored N-doped Carbon Nanosheets

Synergistic Catalytic Biomass-H2o Gasification for H2 Production and Biochar Etching Mechanism: Experimental and DFT Studies