Development of a Compact Synchronizer for Laser-Induced Breakdown Spectroscopy

Li Qiu-shi,Li Jia-ming,Yang Ping,Yang Xin-yan,Hao Zhong-qi,Shen Meng,Zhu Yi-ning,Guo Lian-bo,Li Xiang-you,Zeng Xiao-yan

DOI: https://doi.org/10.3964/j.issn.1000-0593(2018)02-0595-05

2018-01-01

Spectroscopy and spectral analysis

Abstract:The intensities and signal-to-noise ratios (SNRs) of characteristic spectrum are remarkably different under disparate delay times in Laser-Induced Breakdown Spectroscopy(LIBS), which affects the performance of quantitative analysis directly. Conventionally, the general digital delay generator is used to control the delay time in LIBS, butit' s not suitable for compact LIBS equipmentsdue to its large size, high power and high price. In this study, a compact synchronizer (LDG3. 0) with 55 ps resolution was designed and built by using a microcontroller unit and simple circuits. The LDG3. 0 had a considerably smaller size, lower power and lower price than a general digital delay generator DG535. Quantitative analysis of V element in iron samples was investigated to compare the performance of LDG3. 0 and DG535 in LIBSsystem. The results showed that the two LIBS systems with LDG3. 0 and DG535 had almost the same calibration curve of V, and the determination coefficient R-2 were both above 0. 997. The average relative standard deviation(RSD) of V by LIBS system with LDG3. 0 was 2. 28% which slightly smaller than LIBS system with DG535, and the limit of detection (LoD) of the former was 19. 90 mu g.g(-1) which sligthly below the latter. Therefore, the self-builtsynchronizer LDG3. 0 has approximately the same accuracy with DG535 in LIBS systemand meets the control and integration requirements of LIBS. The LDG3. 0 is especially suitable for compact LIBS instruments.