Optimization of lithium adsorption from seawater via aluminum chloride as adsorbent using response surface methodology
Maham HussainFahim UddinNadeem RazaWaqas AleemSadiq HussainAlamin IdrisSalman Qadira University College Dublin School of Chemical and Bioprocess Engineering,Centre for Science,University College Dublin Energy Institute Belfield,Dublin,Irelandb Coal Research Centre,NFC Institute of Engineering & Technology,Multan,Pakistanc Department of Chemical Engineering,NED University of Engineering & Technology,Karachi,Pakistand Department of Chemistry,College of Science,Imam Mohammad Ibn Science Islamic University (IMSIU),Riyadh,Saudi Arabiae DTU Offshore−Danish Offshore Technology Centre,Technical University of Denmark,Kongens Lyngby,Denmarkf Department of Natural Sciences,Mid Sweden University,Sundsvall,Swedeng MoRe Research Örnsköldsvik AB,Ornskoldsvik,Swedenh Dalian Institute of Chemical Physics,Chinese Academy of Sciences,Dalian,PR ChinaMaham Hussain: Conceptualization,Supervision,Project administration,Review,and editing.Fahim Uddin: Software,Formal analysis,original draft writing,Review,and editing.Nadeem Raza: Original draft writing,formal analysis.Waqas Aleem: Validating review and editing,orifical draft writingSadiq Hussain: Conceptualization,Supervision,Project administrationAlamin Idris: Validating Review and editing,orifical draft writing.Salman Qadir: Original draft writing,formal analysis.
DOI: https://doi.org/10.1080/15567036.2024.2310742
2024-02-09
Energy Sources Part A Recovery Utilization and Environmental Effects
Abstract:Lithium extraction from natural resources is an accelerating field of research owing to its growing demand in the medical, nuclear, battery, and air conditioning industries. Lithium compounds are used in various industries, including ceramics, glass, lubricant gases, rocket propellant, and aluminum production. The extraction of lithium from seawater via adsorption using AlCl 3 .6 H 2 O as an adsorbent is investigated in this study. The effect of process parameters such as pH, temperature, contact time, the molar ratio ([Al 3+ ]/[Li + ]), and stirring rate on process efficiency is investigated and optimized. The response surface methodology (RSM) is used to investigate the effects of operating parameters and choose the optimal configuration. A standard synthetic solution containing 50 ppm lithium is prepared and experimented with facilitating comprehension of the procedure. The adsorption efficiency of a synthetic solution is 88% at optimized values, while that of seawater is 78.5%. Seawater has a lower efficiency because it contains ions such as Mg 2+ , Ca 2+ , K + , and Na + that compete for active points/sites during adsorption with lithium ions (Li + ).
energy & fuels,engineering, chemical