Zirconium acetate stabilized tin dioxide colloidal quantum dots as multifunctional electron transporting layer for efficient and stable perovskite solar cells
Yutao Li,Chenyu Zhao,Xinxuan Yang,Lin Fan,Maobin Wei,Huilian Liu,Xiaoyan Liu,Jinghai Yang,Fengyou Wang,Lili Yang
DOI: https://doi.org/10.1016/j.surfin.2023.103546
IF: 6.2
2023-11-02
Surfaces and Interfaces
Abstract:The electron transport layer (ETL) is a significant functional layer for enhancing the power conversion efficiency (PCE) and the environmental stability of perovskite solar cells (PSCs). Tin dioxide (SnO 2 ), which has high conductivity and well-matched energy levels with perovskite films, is widely used as one of the most effective ETLs for PSCs. However, it is still a challenge to reduce the energy loss of the SnO 2 /perovskite interface, which is caused by the SnO 2 quantum dots agglomeration due to its disordered surface charge and the SnO 2 /perovskite interface defects formed during their low-temperature processing. To address this issue, we herein synthesized zirconium acetate stabilized SnO 2 (ZAS) quantum dots to terminate the Sn 4+ at the SnO 2 surface. This suppressed SnO 2 agglomeration and formed a uniform film with enhanced conductivity, thereby reducing the SnO 2 /perovskite interface non-radiative recombination. Furthermore, the C=O and Zr 4+ of ZAS could passivate the Pb 2+ dangling bonds and uncoordinated I − of the perovskite buried surface, respectively. The energy level of the ZAS ETL showed a favorable match with MAPbI 3 , accelerating carrier transport and reducing energy loss. As a result, the optimized ZAS-based device achieved an outstanding PCE of 21.13 % and maintained 90 % of its initial PCE under ambient conditions (25 °C, 30–35 % humidity) after 1000 h. This study not only developed a novel ZAS ETL but also inspired us to focus on modifying the surface properties of single SnO 2 quantum dots rather than that of the SnO 2 film.
chemistry, physical,physics, applied, condensed matter,materials science, coatings & films