Abstract:The lamellae deformation and cavitation behavior of annealed isotactic polypropylene during uniaxial stretching are comprehensively investigated by in situ synchrotron small-angle X-ray scattering and wide-angle X-ray scattering. We reveal how lamellae deformation occurs in the time scales of elastic deformation, intralamellar slip, and melting-recrystallization, separated by three critical strains which are only rarely influenced by annealing. Strain I (0.1) marks the end of elastic deformation and the onset of intralamellar slip, beyond which the crystallinity decreases gradually. Strain II (0.45) signifies the start of the recrystallization process, from where the long period in the stretching direction begins to decrease from its maximum and the polymer chains in the crystal start to orient along the stretching direction. The energy required for melting arises from the friction between the fragmented lamellae produced by intralamellar slip. Strain III (0.95) denotes the end of the recrystallization process. Beyond the strain of 0.95, the long period and the crystal size remain nearly unchanged. During further stretching, the newly formed lamellae serve as the anchoring points for polymer chains in the amorphous phase. The extension of the polymer chains in between lamellae triggers the strain hardening behavior. On the other hand, annealing significantly decreases the critical strain for voids formation and increases the voids number but restricts the void size. For those samples annealed at a temperature lower than 90 degrees C, voids are formed between strain II and strain III, and voids are oriented in the stretching direction once they are formed. However, for those samples annealed at a temperature higher than 105 degrees C, voids are formed between strain I and strain II. In this case, voids are initially oriented with their longitudinal axis perpendicular to the stretching direction and then transferred along stretching direction via void coalescence. Additionally, the formation of voids influences neither the critical strains for lamellae deformation nor the final long period, the orientation of polymer chains, or the crystal size. The final long period, the orientation of polymer chains in the crystal, and the crystal size are determined only by the stretching temperature through melting-recrystallization.

New Insights into Orientation Differences Between Skin and Core Regions of Polyacrylonitrile Fibers During Pre-Stabilization with the Stretching Process

Effects of stretching on crystalline phase structure and morphology of hard elastic PVDF fibers

Plastic deformation of the microfibrils in wet polyacrylonitrile fibers induced by the stretching field

Structural Transformation of Polyacrylonitrile (PAN) Fibers during Rapid Thermal Pretreatment in Nitrogen Atmosphere

Stretch-induced structural evolution of pre-oriented isotactic polypropylene films: An <i>in-situ</i> synchrotron radiation SAXS/WAXS study

Stretch-induced structural evolution of pre-oriented isotactic polypropylene films: An in-situ synchrotron radiation SAXS/WAXS study

Structural Characteristics of Fibrillar Crystals in Uniaxially Stretched Isotactic Polypropylene Dominated by Temperature and Strain

Relationship Between Technics and Properties During PAN Precursors Formation Process

Deformation Mechanisms of Polymer Thin Films by Simultaneous Kinetic Measurement of Microscopic Infrared Dichroism and Macroscopic Stress. Part Iii: Influence of Morphology on Molecular Orientation of Isotactic Polypropylene Films Subjected to Uniaxial Stretching

Effect of Coagulation Conditions on the Radial Moduli of Polyacrylonitrile Nascent Fibers

Application of an Interpenetrating Network Model to the Necking in the Microcrystalline Region in Four Annealed Isotactic Polypropylene Films Subjected to Uniaxial Stretching at Room Temperature

Microstructural Evolution during Dry-Jet Wet Spinning Postprocessing from Coagulation Bath Fiber to High-Performance Polyacrylonitrile Precursor Fiber

Evolution and Regulation of Radial Structure of PAN Pre-Oxidized Fiber Based on the Fine Denier Model

The formation of conjugated structure and its transformation to pseudo-graphite structure during thermal treatment of polyacrylonitrile

Effect of oxygen content on the preoxidation structure of polyacrylonitrile fibers

Comprehensive research on the correlation between microstructure and mechanical properties of polyacrylonitrile‐based precursor fibers prepared by wet‐spinning

In Situ Study and Improvement of the Temperature Increase and Isothermal Retention Stages in the Polyacrylonitrile (PAN) Fiber Pre-Oxidation Process

Study on the structural evolution of polyacrylonitrile fibers in stepwise heat treatment process and its relationship with properties

Critical Strains for Lamellae Deformation and Cavitation During Uniaxial Stretching of Annealed Isotactic Polypropylene

The Formation of Crystal Cross-Linked Network in Sequential Biaxial Stretching of Poly(ethylene Terephthalate): the Essential Role of MD Pre-Stretch

Orientation of Chitin Nanofibers Dispersed in a Thermoplastic Polymer Matrix Through Dry Thermal Stretching