Abstract:To explore room-temperature strengthening and high-temperature ductility, a lightweight novel Mg-1.85Gd-0.64Al-0.62Zn alloy was fabricated by innovative multidirectional forging and a hot-rolling technique. Microstructures and mechanical properties were studied at room and elevated temperatures with an optical microscope, an X-ray diffractometer, and a tensile tester. An ultimate tensile strength of 260 MPa, yield strength of 171 MPa, and elongation of 20.4% were demonstrated at room temperature. The room-temperature strengthening mechanisms were identified by strengthening the model estimation. A type C Portevin-Le Chatelier effect was discovered and elucidated in this alloy. X-ray diffraction analysis revealed that the phase composition is α-Mg solid solution and (Mg, Al)3Gd, Al7Zn3, and Al2Gd intermetallic compounds. Examination of the microstructure at elevated temperatures revealed that dynamic recrystallization and dynamic grain growth occur. In particular, it was discovered that bimodal microstructures or incomplete dynamic recrystallization microstructures exist in high-temperature deformation. A maximum quasi-superplasticity of 228.4% was demonstrated in this alloy at 673 K and 5.0 × 10-4 s-1. Flow stress curves showed that the present alloy exhibits Sotoudeh-Bate curves or a long intermediate strain-hardening stage followed by a strain-softening stage. A modified Zerilli-Armstrong constitutive equation incorporating the number of dislocations was established. The power-law constitutive equation was established to identify the deformation mechanism. Both constitutive models had good predictability. At 673 K and 5.0 × 10-4 s-1, the stress exponent was 4, and the average deformation activation energy was 104.42 kJ/mol. The number of dislocations inside a grain was 146. This characteristic evidence confirmed that dislocation motion controlled by pipe diffusion dominates the rate-controlling process under this condition.

The Portevin-Le Chatelier Effect and Creep Behaviour in A Mg-Ca-Zn-Zr Alloy

Tensile creep behaviors of Mg-10Gd-0.4Zr alloy under the different applied stresses at 260 °C

Room temperature tensile creep behavior of Mg-6Zn-0.4Mn-0.3Al-0.2Ca (wt.%) alloy containing icosahedral quasicrystals

Tensile creep behaviors of Mg-10Gd-0.4Zr alloy in different heat treatment states

High-Temperature Creep Behavior of Mg-9Gd-2Nd-1Ca-0.5Zr Alloy

Microstructural evolution of Mg–14Gd–0.4Zr alloy during compressive creep

Room-Temperature Strengthening, Portevin-Le Chatelier Effect, High-Temperature Tensile Deformation Behavior, and Constitutive Modeling in a Lightweight Mg-Gd-Al-Zn Alloy

Microstructure Evolution and Creep Behavior of High-Pressure Die-Cast Mg–9Al–1Zn–1Sr Alloy

The effect of high solid solution Mg contents (7–13 wt%) on the dynamic strain aging behavior of Al–Mg alloys

Compressive creep behavior of extruded Mg-4Sm-2Yb-0.6Zn-0.4Zr alloy

Opposite effects of Zn addition on the creep resistance at low and high temperatures for as-cast Mg-15Gd alloy

Abnormal creep behavior of Mg-12Gd-1MM-0.6Zr (wt.%) alloy at 300C

Co-deformation Between the Metallic Matrix and Intermetallic Phases in a Creep-Resistant Mg-3.68Al-3.8Ca Alloy

Abnormal creep behavior of Mg–12Gd–1MM–0.6Zr (wt.%) alloy at 300°C

Study on the microstructures and tensile creep behaviors of extruded dilute Mg–Mn–Zn alloys

Understanding solid solution strengthening at elevated temperatures in a creep-resistant Mg–Gd–Ca alloy

Solute-induced strengthening during creep of an aged-hardened Al-Mn-Zr alloy

Anisotropic tensile creep behavior in laser powder bed fusion manufactured Al–Mn–Mg–Sc–Zr alloy

Creep aging behavior of Al-Cu-Mg-Si alloy with elastic and plastic loads

Influence of temperature on creep behavior, mechanical properties and microstructural evolution of an Al-Cu-Li alloy during creep age forming

Precipitate Behavior, Mechanical Properties and Corrosion Behavior of an Al-Zn-Mg-Cu Alloy during Non-Isothermal Creep Aging with Axial Tension Stress