Abstract:The damage caused by soil liquefaction during earthquakes is substantially affected by the total volume and spatial distribution of the liquefied soils. Therefore, a proper characterization of the spatial distribution of liquefaction potential of subsurface soils plays a critical role in earthquake hazard assessment and mitigation. In engineering practice, in situ tests, such as the cone penetration test (CPT), are widely used for evaluating soil liquefaction potential through, e.g., factor of safety (FS) against liquefaction, and the results of liquefaction assessment in a cross-section are needed for subsequent earthquake hazard analysis and mitigation. Traditional simplified methods only provide the liquefaction potential of soils at individual locations, and the results of liquefaction triggering evaluation at individual locations are often used to represent the whole site. This might lead to an unconservative estimation of earthquake-induced deformations and damage at a site where spatial variation of soil properties is significant. In addition, although CPT provides almost continuous sounding along vertical direction, measurements along horizontal directions are usually limited. This leads to the difficulty in proper application of geostatistical methods in liquefaction potential analysis. To address these challenges, a nonparametric and data-driven method is developed in this study to interpret a cross-section of FS with high spatial resolution directly from sparse CPT soundings. Based on the interpreted cross-section of FS, the predicted total volume and spatial distribution of liquefied soils are estimated. Both simulated and real CPT data are used to demonstrate and validate the proposed method, and the results show that the proposed method performs reasonably well.

Evaluation Of Liquefaction Potential Of Saturated Sands Based On Resistivity Piezocone Penetration Testing

Characterizing the Liquefaction Potential and Pore Pressure Generation of Silty Sands Through the Energy-Based Approach in the Framework of Critical State Soil Mechanics

Characterizing the In-Situ State of Sandy Soils for Liquefaction Analysis Using Resistivity Piezocone Penetration Test

EVALUATION OF LIQUEFACTION OF SANDY SOILS BASED ON CONE PENETRATION TEST

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Evaluation Method for the Liquefaction Potential Using the Standard Penetration Test Value Based on the CPTU Soil Behavior Type Index

Liquefaction assessment using standard penetration test valuebased on CPTU soil behavior type index

Assessment of resonance compaction method on soil liquefaction treatment through CPTU test

Seismic Cone Penetration Test Assessment of Vibratory Probe Compaction for Liquefaction Mitigation

Evaluation of Vibro-Compaction for Liquefaction Mitigation by CPTu-based state characterization

In Situ Evaluation Of Relative Density From Piezocone Penetration Tests Of Clean Sand From China

A New Parameter to Evaluate Liquefaction Resistance of Saturated Sand under Complex Dynamic Stress Paths

Study on Liquefaction Estimation Method Based on State Parameters of CPTU in Situ Measurement

Delineating the Spatial Distribution of Soil Liquefaction Potential in a Cross-Section from Limited Cone Penetration Tests

Evaluation of Geotechnical Parameters of a Lagoonal Clay Deposit in Jiangsu Lixia River Area of China by Seismic Piezocone Tests

RE-INVESTIGATING SAND LIQUEFACTION CASE HISTORIES FROM THE TANGSHAN EARTHQUAKE USING MULTI-FUNCTIONAL SEISMIC CONE PENETRATION TESTS

Liquefaction Assessments Using Seismic Piezocone Penetration (scptu) Test Investigations in Tangshan Region in China

Time-Dependent Cone Penetration Resistance of a Postliquefaction Sand Deposit at Shallow Depth

Liquefaction resistance and small strain stiffness of silty sand: Effects of host sand gradation and fines content

A New Empirical Model for the Undrained Shear Strength of Undisturbed Marine Fine-Grained Soil Based on Piezocone Penetration Tests

Evaluating liquefaction resistance of partially saturated sandy soil using the P-wave velocity