Abstract:The piezocone (CPTu) dissipation test is used to characterize how the applied load from the penetrating cone is distributed between the soil and pore fluid during both penetrometer advancement and when penetration is paused. The coefficient of consolidation is often estimated from CPTu dissipation tests by interpreting the rate of excess porewater pressure ( ∆u ) decay to static conditions during a pause in cone penetration. Most CPTu dissipation test interpretation methods are based on Terzaghi consolidation theory for ∆u dissipation at the cone shoulder ( u2 position) or cone face ( u1 position) and assume that radial ∆u dissipation dominates the response. However, several recent studies show that vertical ∆u migration does contribute to the response. This study uses a large deformation direct axisymmetric cone penetration model to characterize the soil-water mechanical response during CPTu dissipation tests, and in particular, the role of vertical ∆u dissipation on the response at the u1 and u2 positions. Large deformations around the penetrating cone are accommodated with an Arbitrary Lagrangian Eulerian approach. Soil behavior is modeled with the MIT-S1 constitutive model calibrated for Boston blue clay (BBC) soil behavior. ∆u dissipation following undrained cone penetration is simulated with coupled consolidation for BBC with over-consolidation ratios (OCR) of 1, 2, and 4 and a range of hydraulic conductivity anisotropy. The simulated u1 and u2 dissipation responses are presented to study how they are affected by OCR and hydraulic conductivity anisotropy. A correction factor is recommended to account for hydraulic conductivity anisotropy when interpreting the horizontal coefficient of consolidation from CPTu dissipation tests.

In Situ Evaluation Of Relative Density From Piezocone Penetration Tests Of Clean Sand From China

Energy-Based Approach to Quantify Cyclic Resistance and Pore Pressure Generation in Anisotropically Consolidated Sand

Interpretation of Piezocone Penetration Tests in Centrifuge

Strength interpretation parameter of piezoncone penetration test for soft clay in offshore area of Hangzhou Bay

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Analysis Of Consolidation Processing Of Piezocone Penetration Test In Cutoff Wall

An Approach to Evaluate Hydraulic Conductivity of Soil Based on Cptu Test

A Penetration Processing Study of Piezocone Penetration Test in Cutoff Wall

A Comprehensive Review of the Evaluation and Application of Engineering Properties of Expansive Soil Based on Piezocone Penetration Test (CPTU)

Assessing the Bearing Capacity of Backfills by Stress Wave Velocity and Cone Penetration Resistance

Applicability Evaluation of a Two-Dimensional Piezoelectric Transducer to Monitor Dynamic Soil Stress in Unbound Granular Materials of Road Engineering

Pore Pressure Response and Dissipation of Piezocone Test in Shallow Silty Soil of Yellow River Delta

Field Behavior of Driven Prestressed High-Strength Concrete Piles in Sandy Soils

Investigation of piezocone dissipation test interpretation in clay accounting for vertical and horizontal porewater pressure dissipation with a large deformation axisymmetric penetration model

Interpretation of centrifuge CPT data in normally consolidated silica and carbonate sands

A Novel Method for Estimating the Undrained Shear Strength of Marine Soil Based on CPTU Tests

Effect of Penetration Rates on the Piezocone Penetration Test in the Yellow River Delta Silt

Influence of the Penetration of Adjacent X-section Cast-in-place Concrete (XCC) Pile on the Existing XCC Pile in Sand

Numerical study of piezoball dissipation test with penetration under partially drained conditions

Effect of Initial Pore Pressure on Undrained Shear Behaviour of Fine-Grained Gassy Soil

Non-monotonic Piezocone Dissipation Curves of Backfills in a Soil-Bentonite Slurry Trench Cutoff Wall