Abstract:Tokamak is a kind of device that uses strong magnetic fields to confine the hot nuclear fuel in plasma state and achieve the controlled thermonuclear fusion reaction. It is well-known that increasing the plasma elongation is beneficial for improving the performance of tokamak. However, high elongation is always along with a strong intrinsic vertical insta-bility. The control system to neutralize the vertical instability of the plasma may fail. As a result, the plasma will move vertically and finally strike on the plasma-facing components accompanied by rapid thermal and current disruption. During this process, large eddy cur-rents will be induced in the plasma surrounding conductive structures and high heat flux will be injected into the first wall of the vacuum vessel (VV). The eddy currents and the temperature gradient then produce strong Lorentz forces and thermal stress, which may cause excessive deformation or even failure of the device. Additionally, there are compli-cated magneto-thermal-mechanical coupling (MTMC) phenomena in the dynamics of the tokamak structures, which may have non-negligible influences on the distribution of the electromagnetic and mechanical loads and the dynamic response of the structure. To en-sure the safety of the tokamak device, it is necessary to make quantitative evaluations of the coupling effects on the transient response of the VV and in-vessel structures during plasma disruptions. In this paper, efficient numerical methods were proposed for solving the structural dynamic problem with MTMC effects. The nonlinear interaction between the magneto-mechanical terms was linearized with a block-Gauss-Seidel iterative algorithm, and an adaptive matrix update algorithm was proposed to cope with the temperature ef-fect on material properties. In addition, an MTMC experiment system with both electro-magnetic load and thermal load was set up to demonstrate the validity and efficiency of the proposed numerical methods. Finally, the dynamic response of the vacuum vessel of HL-2M tokamak during a typical plasma disruption was simulated using our updated nu-merical code, and influences of the MTMC effects were quantitatively evaluated.(c) 2023 Elsevier Inc. All rights reserved.

Numerical Simulation of EMAT Signals for Detection of Debonding in HIP Welding of Multilayer Tubes

Numerical Simulation of EMAT NDT for HIP Welding Joint in W-Cu Mono-Block

Numerical Study on Feasibility of ECT for Detection of Delamination Defect in HIP Welding of Multilayer Tubes

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

A Rotating Bias Magnetic Field EMAT and Applications to NDT of ITER Divertor Components

A Phased-Array Emat for Detection of Delamination Defect in A Tube of Multilayer Structure

A Method For Electromagneto-Thermo-Mechanical Direct Coupling Analysis And Its Application To Tokamak Structures

Detection of Interlayer Delamination in W Monoblock of ITER Divertors Via Electromagnetic Acoustic Transduction

A New Array Eddy Current Testing Probe for Inspection of Small-Diameter Tubes in Tokamak Fusion Devices

Numerical analysis on welding distortion of extruded shape of aluminum alloy floor for EMU

Numerical Simulation Of Temperature Field And Residual Stress In Multi-Pass Welds In 2.25cr-1mo-0.25v Steel Plate And Comparison With Experimental Measurements

Welding Numerical Simulation Analysis of AP 1000 Insert Plate and Penetration Sleeves Based on ABAQUS

Numerical Methods for the Magneto-Mechanical Coupling Analysis of Invessel Components in Tokamak Devices

Numerical Method and Experimental Validation of the Magneto-Thermal-mechanical Coupling Problem with Application to Tokamak Structures

EMD of EMAT NDT in X70 Pipeline Weld Defects

Application of E-Beam Welding in W/Cu Divertor Project for EAST

A Hybrid Method for Efficient Simulation and Feasibility Study of Guided-wave Electromagnetic Acoustic Transducers for Inspection of Metallic Tubes with Small Diameters

Development of Simulation Method for EMAT Signals and Applications to TBC Inspection

An FEM-BEM Method for Halo Current Problem and Its Application to HL-2M Tokamak

Numerical simulation of coupled arc-droplet-weld pool behaviors during compound magnetic field assisted gas metal arc welding

The On-Line Identification and Location of Welding Interference Based on CEEMD