Abstract:In this paper, the effect of micro-dimple textures (produced by a laser) on the tribological properties of bearings is investigated. This study offers guidelines to reduce the friction torque of the bearing pair and addresses the problem of difficult start-ups after shutdowns. Micro-pits with different texture diameters and depths were machined on the surface of journal bearings. Then, the impact of several different texture parameters on the tribological performance of the bearing pairs was studied using an orthogonal experimental design. Subsequently, the surface morphology of the bearings before and after the friction and wear test was observed using scanning electron microscopy (SEM) and energy-dispersive spectrometry (EDS). These observations were then used to determine the type/state of friction and wear, which also improves our understanding of how texture affects the service life of bearings. The results indicate that the bearings’ micro-pit surface hardness follows an approximate parabolic spatial distribution that decreases along the micro-pit wall. Furthermore, the laser processing of surface textures was found to cause hardening in certain areas, and the chemical composition of elemental carbon and oxygen at the inner surface of processed bearings increased by 31.1% and 7.9%, respectively. Moreover, abrasive wear was identified as the primary form of wear. The textured surface’s antifriction mechanism primarily functioned to trap particles, which acted as a secondary lubrication source and altered the lubrication states by serving as a medium for supplied lubricants. The results confirm that a suitable selection of texture parameters can not only effectively reduce the friction coefficient without shortening the service life of the bearing pair but also facilitate the smooth start-up of the rotor–bearing system.

Study of Acoustic Performance of Textured Journal Bearing

Experimental investigation for vibration reduction of surface-textured journal bearings

Effects of Compound Groove Texture on Noise of Journal Bearing

Effects of three types of surface texture on the performances of journal bearing

Influences of Operation Parameters on Noise of Journal Bearing with Compound Texture Considering Lubricant Thermal Effect

Hydrodynamic Lubrication of Partial Textured Sliding Journal Bearing Based on Three-Dimensional CFD

Parametric Design of Surface Textures on Journal Bearing

Effect of Dimple on Tribological Performances of a Journal Bearing

Experimental Study of Compound Texture Effect on Acoustic Performance for Lubricated Textured Surfaces

Study on Tribological Performances for Textured Bearing of ICE

Preliminary Study on Mechanism of Cavitation in Lubricant of Textured Sliding Bearing

The Effect of Surface Textures on Loading Capacity of Journal Bearing Lubricating Film

Comparative Study of Spherical Dimple and Bump Effects on the Tribological Performances of Journal Bearing

Performance of Textured Foil Journal Bearing Considering the Influence of Relative Texture Depth

Direct Observation of Cavitation Phenomenon and Hydrodynamic Lubrication Analysis of Textured Surfaces

A Study on Micro-Pit Texture Parameter Optimization and Its Tribological Properties

Study of offset factor and depths of dimple on the performance of two-lobe journal-bearings

Effect of Micro-texture on Cavitation Distribution of Journal Bearing Friction Pair

Research on Load Carrying Properties of Surface Textured Journal Bearing

Study of grease lubricated journal bearing with partial surface texture

Modeling a Hydrodynamic Bearing with Provision for Misalignments and Textures