Abstract:Residual stresses can have detrimental effect on the life cycle of engineering components and can affect the accuracy of the fatigue life prediction models. Accurate measurement of these stresses are therefore crucial. . However, destructive and semi-destructive methods of measuring residual stresses often cause damage to the components. In contrast, the non-destructive ultrasonic method allows for intact measurement of residual stresses even, in situation where portability is not feasible. Various waves can be utilized in the ultrasonic method for measuring residual stresses. In this study, longitudinal critically refracted (LCR) waves were employed due to their higher sensitivity, larger scanning area, and lower sensitivity to texture effect, making them preferable over other waves. The purpose of this study was to investigate the influence of plasticity on the measurement of residual stresses using the ultrasonic method. To achieve this, two stainless steel disks were subjected to quenching at temperatures of 300 °C and 700 °C to induce different levels of residual stresses and plasticity. The material properties of the disks were determined through standard tensile tests to facilitate numerical simulations. Tensile test specimens were extracted from the initial sheet to measure the yield stress and modulus of elasticity. The coefficient of acoustoelasticity, was determined by subjecting the tensile test specimens to different stress levels and recording the wave flight time. The coefficient of acoustoelasticity for stainless steel 316Lwas obtained using the slope of and (E(t-t0))/t0,. Residual stresses were experimentally measured using both the ultrasonic method and the center-hole drilling method, and the results were compared with those obtained from numerical analyses. The findings from center-hole drilling method, ultrasonic method, and numerical simulation were then compared and discussed. Different levels of plasticity were considered, and the accuracy of measuring residual stresses was analyzed and evaluated.

Finite Element Analysis of Residual Stress Evolution with Multiple Impacts on One Point in Ultrasonic Impact Treatment Process

Finite Element Method Simulation for Residual Stress in Quenched Aluminum Alloy Thick-Plate and Its Effect on Machining Distortion

Finite Element Simulation of Residual Stress Field Induced by Ultrasonic Impact Treatment

Experimental and Numerical Simulation to Study the Reduction of Welding Residual Stress by Ultrasonic Impact Treatment

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Numerical simulation of the effect of ultrasonic impact treatment on welding residual stress

Numerical study of the ultrasonic impact on additive manufactured parts

Numerical Simulation of Residual Stress Field Induced by Ultrasonic Shot Peening

Numerical study on local residual stresses induced by high frequency mechanical impact post-weld treatment using the optimized displacement-controlled simulation method

Finite Element Analysis of Transient Welding Stress and Strain During Ti-6al-4v Thin Plate Welding with Impact Rotation

Evaluation of UIT on titanium alloy residual stress eliminating by ultrasonic residual stress measurement system

A Novel Multiple Impact Model for Predicting the Residual Stress State

Finite Element Simulation for Residual Stresses in Weling Process

A practical analysis of residual stresses induced by high-frequency mechanical impact post-weld treatment

Optimization of residual stresses generated by ultrasonic nanocrystalline surface modification through analytical modeling and data-driven prediction

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

Finite Element Analysis and Experimental Study on Welding Residual Stress of Heavy-Duty Turning Tool

Stability of Residual Stresses in Ultrasonic Surface Deep Rolling Treated Ti-6Al-4V Alloy under Cyclic Loading

A new combined impact fatigue damage model and its application of influencing factors analysis on impact fatigue of TC18 titanium alloy

Finite Element Analysis for Shot-Peening Models of Single Shot Impact and Multiple Impingement

Modification of Residual Stresses in Laser Additive Manufactured AlSi10Mg Specimens Using an Ultrasonic Peening Technique