Abstract:Molecular dynamics simulations were performed to study the influence of system size on wave propagation and deformation patterns in < 1 0 0 >/{1 0 0} copper nanobars with square cross-section under symmetric longitudinal impact loading. Nanobars of longitudinal length 100a with cross-sectional edge lengths h = 10a, 20a, and 40a were impacted on both ends by flyers of size 20a x h x h, where a is the Cu unit cell length, and impact speed 500 ms(-1). For reference, quasi-infinite slab samples with periodic cross-sectional edge lengths 10a and 40a were also studied. It was found that the wave propagation speed increases with increasing cross-sectional area and eventually approaches the value obtained for a quasi-infinite sample. Extensive plasticity occurs across the entire length of the nanobars, whereas the quasi-infinite samples remain in the elastic regime and exhibit a vibrating (ringing) behaviour. The deformation pattern in the nanobars is strongly dependent on the cross-sectional area. For the nanobar with h = 10a the material fully reorients from < 1 0 0 >/{1 0 0} to < 1 1 0 >/{1 1 1} with few stacking faults and twins. Material in the nanobar with h = 20a does not reorient completely; the local crystal deformation is mediated mainly by a partial dislocation activity leading to predominantly non-intersecting stacking faults and twins. Nanobars with h = 40a exhibit behaviour similar to that for the h = 20a case but with greater propensity for intersecting stacking faults.

Molecular Dynamics Simulations of Void Effect of the Copper Nanocubes under Triaxial Tensions

Atomistic Numerical Investigation of Single-crystal Copper Nanowire with Surface Defects

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Molecular Dynamics Study Of Dynamic Buckling Properties Of Nanowires With Defects

Exploration of the Defect’s Effect on the Mechanical Properties of Different Orientated Nanowires

Numerical Exploration of Plastic Deformation Mechanisms of Copper Nanowires with Surface Defects

Atomistic Exploration of Deformation Properties of Copper Nanowires with Pre-Existing Defects

Simulating Size and Volume Fraction-Dependent Strength and Ductility of Nanotwinned Composite Copper

Investigation on void growth and coalescence in single crystal copper under high-strain-rate tensile loading by atomistic simulation

MD Investigations for Mechanical Properties of Copper Nanowires with and Without Surface Defects

Numerical Exploration Of The Defect'S Effect On Mechanical Properties Of Nanowires Under Torsion

Molecular Dynamics Study on the Nano-Void Growth in Face-Centered Cubic Single Crystal Copper

Molecular dynamics simulation on elastoplastic properties of the void expansion in nanocrystalline copper

Multiaxial Behavior of Nanoporous Single Crystal Copper: a Molecular Dynamics Study

Coupling Effect of Twin Boundary and Void on the Mechanical Properties of Bulk Nanotwinned Copper: an Atomistic Simulation

An investigation of the combined size and rate effects on the mechanical responses of FCC metals

Atomistic modeling size dependence of nano-voided copper yielding under uniaxial tension

Studying the elastic properties of nanocrystalline copper using a model of randomly packed uniform grains

Effect of stress-triaxiality on void growth in dynamic fracture of metals: a molecular dynamics study

Deformation of Copper Nanowire under Coupled Tension–Torsion Loading

Size Effects on the Wave Propagation and Deformation Pattern in Copper Nanobars under Symmetric Longitudinal Impact Loading