Abstract:To accurately predict welding-induced residual stress and strain of high strength steel thick plate EH40 butt joint in single-pass full penetration laser welding, a complete solid phase transformation model according to the actual weld microstructure was proposed through material constitutive development. At the same time, the Case 1 considering the traditional thermo-elastoplastic were used as comparative study. The simulation calculation results and experimental results of each phase content were compared and verified. The stress and strain distribution of welded joints and the evolution mechanism of nodes in three zone including fusion zone, heat-affected zone and base metal were deeply studied and compared. The results indicated that the solid phase transformation had an obvious effect on the peak and distribution of longitudinal, transverse, normal and equivalent residual stress, as well as the stress gradient at the junction of heat-affected zone and BM. It increased the peak value of longitudinal residual compressive stress from –103 MPa to –768 MPa, with an increase of 645.6%. The stress gradient at the junction of heat-affected zone and base metal was up to 1299 MPa. The state distribution of longitudinal and transverse stress in the weld and its vicinity were completely opposite to the Case 1. The peak value of transverse plastic compressive strain increased from –0.059 to –0.111, with an increase of 88.1%. The fusion zone and heat-affected zone of the plastic strain in welded joints were more easily observed. It was found that martensitic transformation was the main reason for the obvious difference of stress and strain distribution and the evolution mechanism of stress and strain in the later stage of cooling stage.

Analysis of Strain Field Near Stagnation Point in Explosive Welding

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Mechanism of Explosive Technique on Relieving Welding Residual Stresses

Fundamental research of welded plastic strain evolution process II: Evolution process of welded plastic strain in thin stainless steel plate

Welding residual stress analysis of the X80 pipeline: simulation and validation

Evolutions of temperature field and stress field in narrow gap oscillating laser welding process based on equivalent heat source

Computational Analysis on Weld Formation Mechanism during Self-Reacting Friction Stir Welding

Finite element and experiment analysis of welding residual stress in S355J2 steel considering the bainite transformation

A New Microstructural Approach to the Strength of an Explosion Weld

Numerical Study on Mechanism of Explosive Welding

Fundamental research of welding plastic strain evolution process: Characteristics and law of evolution process of welding plastic strain in mild steel, stainless steel and titanium alloy thin plate

Static Analysis for Weld-Bonded Single-Lap Shear Joint with Multiple Weldspots

Strain incompatibility as a source of residual stress in welding and additive manufacturing

Solid phase transformation effects on stress and strain in the thick plate EH40 welded butt joint

Finite element analysis of the angular distortion and residual stress in underwater wet welding

An Inverse Approach for Constructing the Residual Stress Field Induced by Welding

Finite element synthesized analysis of the forming process of spiral welded pipe

Numerical and experimental study on thermal-metallurgical-mechanical behavior of high-strength steel welded joint

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Residual Stress Analysis in Linear Friction Welded Ti17

Recent developments in analysis and testing of spot welds