Abstract:In operation, residual stresses will superimpose with load stresses affecting service life of welded constructions. Therefore, knowledge of the exact residual stress state is of great interest already in the design state. Experimental determination of residual stresses is possible using destructive and non-destructive methods. Especially for larger structures and small batch sizes destructive measuring techniques can be neglected. Non-destructive methods, however, do have process-specific disadvantages such as the limited resolution. Furthermore, residual stress gradients in the direction of sheet thickness cannot be determined. An alternative approach would be the virtualization of the design using the finite element method (FEM). The application of FEM gives an insight into residual stresses at each point of the computed model, in particular at areas which are not accessible to measurement. However, the use of the FEM for residual stress calculation is subject to certain limits and error sources due to the fine discretization and the high degree of non-linearity. In particular, the calculation of multi-layer welds will reach high computation times, even with high available computing capacities. Therefore, the calculation's practical benefit is hardly recognizable. This known issue is often counteracted with radical simplification of the welding task to be calculated. Simplification approaches such as reduction of layer numbers or semi-transient calculations result in manageable computing times, but can also lead to result accuracies, the quality of which must be questioned. This led to the following questioning. Which simplification strategies are applicable in numerical welding simulation in order to achieve acceptable accuracy by means of an application-oriented manner? For this purpose, reference models were produced that were experimentally verified. On this basis, simplification approaches were investigated numerically and their effects on result quality were quantified. It could be shown that most of the commonly used simplification approaches for the calculation of residual stresses and distortions are only partially permissible, if any.

An Inverse Approach for Constructing the Residual Stress Field Induced by Welding

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

A physically consistent 2D residual stress model for approximating 3D effects in welding

The Characteristics of the Source of Welding Residual Stress (Inherent Strain) and its Application to Measurement and Prediction

Full-Field Eigenstrain Reconstruction For The Investigation Of Residual Stresses In Finite Length Weldments

Reconstruction of Residual Stress in a Welded Plate Using the Variational Eigenstrain Approach

An Inverse Approach for Constructing Residual Stress Using BEM

An Inverse Approach to Construct Residual Stresses Existing in Axisymmetric Structures Using BEM

Investigation of Residual Stress in Butt-Welded Plates Considering Phase Transformation

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Finite-element inverse analysis of residual stress for laser welding based on a contour method

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Multiphysics Study of Thermal Profiles and Residual Stress in Welding

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

An approach for obtaining surface residual stress based on indentation test and strain measurement

Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality

Accuracy of computational welding mechanics methods for estimation of angular distortion and residual stresses

Welding residual stress analysis of the X80 pipeline: simulation and validation

Residual Stresses Simulation for Friction Stir Welded Joint

An inverse approach for constructing planar residual stresses using bem