Abstract:An experimental study of flow control over conical body by nanosecond pulse dielectric barrier discharge (NS-DBD) plasma actuation at Re-D = 3.09 x 10(5) (v = 42 m/s) is presented. First, the fundamental characteristics and control mechanisms of the plasma actuator were studied in the quiescent atmosphere. NS-DBD plasma actuator is an economical effective device because of its high discharge voltage/frequency (similar to 20 kV/20 kHz), but short pulse duration time (similar to 20 ns). Plasma actuators with different geometries were studied using the Schlieren technique. On the microsecond time scale, combination compression waves that consisted of a hemisphere wave and a planar wave were generated by rapid gas heating. The propagation velocity produced during the initial stage (10-40 mu s) can potentially reach the sonic level (similar to 350 m/s). On the millisecond time scale, two starting vortices rolled up from two opposite directions, and then developed into one perturbation downstream. NS-DBD plasma actuation influences the flow by rapid localized heating and transferring energy to the near-wall gas. In the wind tunnel experiment, a pair of NS-DBD plasma actuators mounted symmetrically on the surface of the model apex were applied to control the asymmetric vortex flow field. Actuators were, respectively, aligned along the line of azimuth angles of theta = +/- 80 degrees, +/- 90 degrees, and +/- 100 degrees, under positive and negative discharges. The test results include the pressure distribution sampled over the measurement station and the calculated lateral force coefficient. The efficacy of NS-DBD plasma actuation for controlling the asymmetric vortex over conical body was demonstrated with arrangements theta = +/- 80 degrees and theta = +/- 90 degrees. The results suggest that the actuator should be set before the suction peak point. When the flow started to accelerate and separate, the small perturbation created by NS-DBD could hardly control the flow. Pressure distributions under plasma actuation with different discharge directions indicate that the control power of NS-DBD is directional and is located along the discharge direction. The actuation with positive discharge delays the separation, whereas the actuation with negative discharge fixed separates the flow.

Investigation Of Airfoil Leading Edge Separation Control With Nanosecond Plasma Actuator

Keynote: Study of Airfoil Leading Edge Separation Control Using Pulsed Nanosecond Plasma Actuator

Investigation of Flow Separation Control with Dielectric Barrier Discharge Plasma Actuator

Flow Separation Control over a NACA 0015 Airfoil Using Nanosecond-Pulsed Plasma Actuator

Investigation of Flow Separation Control over Airfoil Using Nanosecond Pulsed Plasma Actuator

Study on the Plasma Active Control in the Low-speed Airfoil Separation Flow

Leading-edge Flow Separation Control over an Airfoil Using a Symmetrical Dielectric Barrier Discharge Plasma Actuator

Compressor Airfoil Separation Control Using Nanosecond Plasma Actuation at Low Reynolds Number

Flow separation point control by new plasma actuator

Flow Separation Control over an Airfoil Using Plasma Co-Flow Jet

Influence of Actuating Position on Asymmetric Vortex Control with Nanosecond Pulse Dbd Plasma Actuators

Airfoil Leading Edge Separation Flows under Control of Plasma Actuator

Turbulent Boundary Layer Separation Control Using Plasma Actuator at Reynolds Number 2000000

Novel Sawtooth Dielectric Barrier Discharge Plasma Actuator for Flow Separation Control

Flow Separation Control over an Airfoil Using Continuous Alternating Current Plasma Actuator

Laminar-Separation-Bubbles Flow Control over Airfoil Using SDBD Plasma Actuator

A Comparative Study of Alternating Current and Nanosecond Plasma Actuators in Flow Separation Control

Flow Control of High-Speed Airfoil by Dielectric Barrier Discharge Plasma Actuator

Numerical Research and Analysis of Plasma Control of Airfoil Separated Flow

Airfoil Performance Enhancement with a Novel Flow Control Method of SDBD Plasma Co-Flow Jet

Control of Separated Flow on a NACA 0015 Airfoil using Three-Dimensional Plasma Actuator