Abstract:The characteristics of the vortex cores over a 20°circular-cone forebody under plas-ma actuation are studied at 45°angle of attack.Two long strips of SDBD plasma-actuators are installed symmetrically on the plastic frontal cone near the apex.The length of the electrodes is 20 mm along the cone meridian with the leading edge located at 9 mm from the cone apex.Two AC power sources connected to the plasma actuator respectively.The peak-to-peak voltage and frequency are set at V p-p ≈14 kV and f ≈8.9 kHz,respectively.The input power for the plasma on is about 19.3 W.The induced jet flow is pointed at the windward side.Section velocity distribution and pressure distribution are measured in a low-turbulence 3.0 m×1.6 m low-speed open-circuit wind tunnel.The Reynolds number based on the base diameter of the circular cone is 5 ×104 . The effects of the plasma actuations on the flow physics,such as lateral force,vortex core center position,axial vorticity,vortex core radius,vortex sub-core radius,vortex maximum tangential velocity and circulation are studied.The actuation of plasma actuator on one side pushes the same-side boundary-layer separation point in the windward direction and pulls the other-side sepa-ration point in the leeward direction.The suction peak is decreased on the same side and increased on the other side.The separation shear layer and rolled-up vortex core move out on the same side and close in on the other side.In repetition wind tunnel runs of the same model,the flow asym-metry pattern remains unchanged for port-on and starboard-on,while may be changed for plasma-off coses.The plasma actuations tend to increase significantly the size of the vortex core and increase fairly the size of the vortex sub-core,thus,the vortex sub-core becomes more compact relative to the vortex core than that of plasma-off.Vortex core center may be biased from the mid-point be-tween the maximum tangential-velocity points along radial line passing through the vortex core center due to the plasma actuations.The plasma actuation may strengthen vortex maximum axial vorticity,in case the vortex is dispersed for plasma off.

Plasma Actuator Separation Control Investigated with Spectral Proper Orthogonal Decomposition

Wing Flow Separation Control Using Asymmetrical and Symmetrical Plasma Actuator

Airfoil Leading Edge Separation Flows under Control of Plasma Actuator

Study on the Plasma Active Control in the Low-speed Airfoil Separation Flow

Laminar-Separation-Bubbles Flow Control over Airfoil Using SDBD Plasma Actuator

Numerical Research and Analysis of Plasma Control of Airfoil Separated Flow

Investigation of Flow Separation Control with Dielectric Barrier Discharge Plasma Actuator

Flow Control of High-Speed Airfoil by Dielectric Barrier Discharge Plasma Actuator

Turbulent Boundary Layer Separation Control Using Plasma Actuator at Reynolds Number 2000000

Heat Transfer Characteristics of Plasma Actuation in Different Boundary-Layer Flows

Leading-edge Flow Separation Control over an Airfoil Using a Symmetrical Dielectric Barrier Discharge Plasma Actuator

Optimized Plasma Actuation On Asymmetric Vortex Over A Slender Body

Flow Control over a Cylinder Using Duty-Cycle Plasma Actuation

Flow Control over a Conical Forebody Using Duty-Cycled Plasma Actuators

Investigation Of Airfoil Leading Edge Separation Control With Nanosecond Plasma Actuator

PIV experimental study on flow characteristics of periodic-pulsed dielectric-barrier-discharge

Numerical Investigation of Flow Separation Control over Rotor Blades Using Plasma Actuator

Flow separation point control by new plasma actuator

Novel Sawtooth Dielectric Barrier Discharge Plasma Actuator for Flow Separation Control

Study on forebody separation vortices using plasma actuations

Unmanned Air Vehicle Flow Separation Control Using Dielectric Barrier Discharge Plasma at High Wind Speed