Abstract:Abstract 1,3‐Dienes/styrene sequence‐controlled copolymers are widely used as thermoplastic elastomers, transparent impact resin and synthetic rubber and other materials. In this work, the binary anionic copolymerization of styrene ( S ) and C5‐dienes including 1,3‐pentadiene ( P , E / Z = 65/35) and isoprene ( I ) were studied in cyclopentyl methyl ether (CPME) ‘green’ solvent using n ‐BuLi as initiator, and the effects of copolymerization monomer ratio and polar additive (PA) on the copolymerization kinetics and monomer sequence distributions were investigated. The kinetic analysis results showed that all copolymerization systems were the first‐order reaction and the C5‐dienes/ S could be quantitatively consumed. The addition of S or I was conducive to the efficient conversion of P . Although the addition of PAs had little effect on the polymerization rate, it had a great influence on the microstructure and sequence distribution of the copolymer. 1 H NMR tracking analysis showed that, for S/P copolymerization with different feeding ratios 1/3 < f P < 2/3, the instant composition F P in the copolymer remained relatively constant at 15% < F P < 35% when the monomer conversion rate was below 60%, and thus the inevitable formation of P microblocks in subsequent polymerization sequences was observed. Additionally, similar sequence distributions were obtained in the case of I/P copolymerization systems. By contrast, S / I copolymerization conformed to the typical random copolymerization pattern, and the copolymerization activity of S was slightly higher than that of the I in CPME. The use of strong PAs such as 2,2‐di(2‐tetrahydrofuran)propane directly resulted in a change of monomer sequence from a random pattern to a gradual block pattern. Moreover, the 3,4‐isoprene branch units were much more sensitive to solvent and PA than 1,2‐pentadiene units for C5‐dienes; also Fourier transform infrared and DSC analysis verified the microstructure and sequence analysis results mentioned above. In addition, the results of gel permeation chromatography showed that the copolymerization process in CPME had excellent controllable characteristics. © 2023 Society of Industrial Chemistry.

Synthesis of Primary Amine Functionalized Styrene/Butadiene Copolymer and Contol of Its Composition Distribution

Targeting Copolymer Composition Distribution Via Model-Based Monomer Feeding Policy in Semibatch Raft Mini-Emulsion Copolymerization of Styrene and Butyl Acrylate

Tailoring Uniform Copolymer Composition Distribution Via Policy II RAFT Solution Copolymerization of Styrene and Butyl Acrylate

Programmed Synthesis Of Copolymer With Controlled Chain Composition Distribution Via Semibatch Raft Copolymerization

Semibatch RAFT Polymerization for Producing ST/BA Copolymers with Controlled Gradient Composition Profiles

Control of Diffusion/Barrier Effects of Polymer-Coated Particles and the Strengthening of Ethylene Polymerization Reactor

Studies on Anionic Continuous Solution Copolymerization of Butadiene/Styrene with N-Buli Initiator

Synthesis, kinetic study and characterization of C5 ‐dienes/styrene copolymers via living anionic polymerization in cyclopentyl methyl ether solvent

1,3-Pentadiene-Assistant Living Anionic Terpolymerization: Composition Impact on Kinetics and Microstructure Sequence Primary Analysis

Synchronous Regulation of Periodicity and Monomer Sequence During Living Anionic Copolymerization of Styrene and Dimethyl-[4-(1-phenylvinyl)phenyl]silane (Dpe-Sih)

Synthesis of high vinyl solution polymerized styrene-butadiene rubber with three-peak distribution using mixed coupling agents

Preparation and Dynamic Mechanical Properties of Copolymers Based on Butadiene, Isoprene, and Styrene

Synthesis and Characterization of Random Styrene–butadiene Copolymer with Nd-based Catalyst

In-Chain Multi-Functionalized Polystyrene by Living Anionic Copolymerization with 1,1-Bis(4-dimethylaminophenyl)ethylene: Synthesis and Effect on the Dispersity of Carbon Black in Polymer-Based Composites

The Effect of [pph3]/[ni] in the Synthesis of SBS Via Changing Catalytic Active Centers from A Novel Synthetic Strategy for Styrene–butadiene–styrene Tri-Block Copolymer with High Cis-1,4 Units Via Changing Catalytic Active Centres

Study on the Regulation of Living Anionic Alternating Copolymerization of 1-(4-dimethylsiloxphenyl)-1-styrene and Isoprene

Synthesis, Copolymer Composition, and Rheological Behavior of Functionalized Polystyrene with Isocyanate and Amine Side Groups

Study on Temperature-Controlled Branching Behavior with Self-Condensing Atom Transfer Radical Copolymerization of Latent Inimer and Styrene

Synthesis of Star-Comb Copolymer Pb-G-Pmma by Mechanism Transformation

Synthesis of a sequence-controlled in-chain alkynyl/tertiary amino dual-functionalized terpolymer via living anionic polymerization

Anionic Synthesis of Binary Random In-Chain Multi-Functionalized Poly(Styrene/Butadiene/Isoprene and Dimethyl [4-Phenylvinyl)-phenyl]silane) (Ps-Dpesih, Pb-Dpesih, Pi-Dpesih) Copolymers