Abstract:The assessment of mechanical properties of metal foil under complicated stress states poses a considerable challenge, requiring the development of new testing methods and the optimization of new specimen geometry. In this research, the biaxial tensile method and specimen shape were designed and optimized by using simulation and experiment. It is determined that the strain measurement area can be suggested as the central area of 0.6 to 0.8 times the arm width. The influence of different parameters on the tensile results of cruciform specimens was comprehensively evaluated by finite element method and multi-factor analysis. The results indicate that the number of slits markedly impacts the stress-strain uniformity and shear stress in the central region, followed by the slit length. The effect of the arm width and the slit width is comparable, more influential than the corner radius. According to the analyzed results and application requirements, a four-axis independently driven biaxial tensile test machine for small scale samples was fabricated. During the biaxial tension, the center point offset of the specimen remains within +/- 0.01 mm. The displacement and load synchronization errors do not exceed 0.01 mm and 50 N, respectively, facilitating the precise control of four-axis synchronization. Conclusively, cruciform specimens featuring diverse geometric characteristics were designed for industrial pure titanium, 304 stainless steel, and Inconel 718 superalloy with thickness of less than 0.3 mm. The biaxial tensile tests were performed to delineate the yield loci, revealing notable anisotropy and size effect. The validation confirms the suitability of the testing method and optimized cruciform specimens for conducting biaxial tensile mechanical properties testing on metal foils characterized by diverse types and thicknesses.

Cruciform Specimen Design for Large Plastic Strain During Biaxial Tensile Testing

Design of a biaxial tensile testing device and cruciform specimens for large plastic deformation in the central zone

Novel Design of Cruciform Specimens for Planar Biaxial Testing of Soft Materials

Study of DP590 High-Strength Steel Sheet Cruciform Specimen for Biaxial Tensile

FEM design of cruciform biaxial tensile specimen based on limit stress analysis

Fem design of cruciform biaxial tensile specimen based on limit strain analysis

Cruciform specimens biaxial extension performance relationship to constitutive identification

Investigation on the Biaxial Tensile Testing Method for Metal Foil Using Cruciform Specimen

Biaxial Tensile Behavior of Ti-6Al-4V under Proportional Loadings at High Strain Rates

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

A Novel Methodology for Large Strain under Intermediate Strain Rate Loading

Design of a Cruciform Biaxial Tensile Specimen for Limit Strain Analysis by FEM

A Review of Cruciform Biaxial Tensile Testing of Sheet Metals

A novel mechanical attachment for biaxial tensile test: Application to formability evaluation for DP590 at different temperatures

Biaxial Extension of Cruciform Specimens: Embedding Equilibrium Into Design and Constitutive Characterization

Shear characteristics and failure mechanism of laser metal deposition GH4169 at different strain rates

In-situ Investigation of the Anisotropic Mechanical Properties of Laser Direct Metal Deposition Ti6Al4V Alloy

Biaxial Tensile Behavior of Ti-6Al-4V under Proportional Loading

Accurate Characterization of Biaxial Stress-Strain Response of Sheet Metal from Bulge Testing

Experimental and numerical investigation of combined isotropic-kinematic hardening behavior of sheet metals

Investigation of evolving yield surfaces of dual-phase steels