Abstract:Previous studies on laterally loaded piles in clay have mainly focused on flexible and rigid piles. Little attention has been paid to semi-rigid piles (whose pile–soil stiffness lies somewhere between those of rigid and flexible piles), which may behave as either flexible piles or rigid piles, depending on the change in soil stiffness during cycling. This study aims to understand the cyclic lateral response of a repeatedly loaded semi-rigid pile in soft clay and the failure mechanisms of the soil around the pile, through a series of centrifuge model tests and three-dimensional finite element analyses using an advanced hypoplastic clay model. Numerical parametric studies were also performed to investigate the evolution of soil flow mechanisms with increasing pile rigidity. It is revealed that the semi-rigid pile behaved as if it were a flexible pile (i.e., flexural deformation dominated) during the first few cycles, but tended to behave like a rigid pile (i.e., rotational movement prevailed) during subsequent cycles, which progressively softened the surrounding soil. As a result, the mechanisms of soil flow around the semi-rigid pile exhibited an intermediate behaviour combining the mechanisms of both flexible and rigid piles. Three distinctive mechanisms were identified: a wedge-type mechanism near the surface, a full-flow mechanism (within the transverse sections) near the middle of the pile, and a rotational soil flow mechanism (in the vertical symmetrical plane of the pile) near the lower half of the pile. By ignoring the rotational soil flow mechanism, which has a much lower resistance than the full-flow mechanism, the American Petroleum Institute code (published in 2007) underestimated the cyclic bending moment and the lateral pile displacement by 10% and 69%, respectively. Application of jet grouting around the semi-rigid pile at shallow depth significantly altered the soil flow mechanism (i.e., it was a solely wedge-type mechanism around the grouted zone).

Experimental and numeikal analysis of a 4x4 pile group in liquefiable ground

Vertical Vibration of A Partially Embedded Pile Group in Transversely Isotropic Soils

Centrifuge Shaking Table Tests on 4 × 4 Pile Groups in Liquefiable Ground

Dynamic Impedances and Free-Field Vibration Analysis of Pile Groups in Saturated Ground

Dynamic Response and Load Distribution of Pile Groups in Layered Liquefiable Ground

Three Dimensional Numerical Simulation of Piles in Liquefiable Ground

Analysis Of Seismic Single Pile Response In Liquefiable Ground

CENTRIFUGE SHAKING TABLE TEST ON SINGLE PILE IN LATERAL SPREADING SOIL

Analysis method for pile groups subjected to lateral and torsional loads

Study on Vertical Load Distribution of Pile Group–Liquefied Soil System under Horizontal Seismic Environment

Finite Element Model for Piles in Liquefiable Ground

Seismic performance of pile group-structure system in liquefiable and non-liquefiable soil from large-scale shake table tests

Numerical Analysis of the Seismic Inertial and Kinematic Effects on Pile Bending Moment in Liquefiable Soils

Seismic Performance of Pile Groups under Liquefaction-Induced Lateral Spreading: Insights from Advanced Numerical Modeling

Numerical analysis for the vertical bearing capacity of composite pile foundation system in liquefiable soil under sine wave vibration

Dynamic Response Analysis of Pile Group Foundation of Super-Giant Sewage Treatment Structure on Hydraulic Fill Foundation

Lateral Dynamic Responses of Coastal Group Piles Considering Pile‒water‒soil Interactions

Seismic response comparison and sensitivity analysis of pile foundation in liquefiable and non-liquefiable soils

Analysis on Kinematic and Inertial Interaction in Liquefiable Soil-Pile-structure Dynamic System

Numerical Analysis on Seismic Response and Failure Mechanism of Articulated Pile–structure System in a Liquefiable Site from Shaking-Table Experiments

Cyclic Lateral Response and Failure Mechanisms of Semi-Rigid Pile in Soft Clay: Centrifuge Tests and Numerical Modelling