Abstract:The Finite Element method was used to analyze the dynamic response of pile groups in the ground subjected to the liquefaction-induced lateral flow of soils.The u-p Finite Element for-mulation was used to depict the coupling effect of water and sand soil particles in the Finite Ele-ment analysis.A 3D numerical model was developed to analyze the effect of a 2×2 pile group sub-jected to liquefaction-induced lateral spreading.In this model,sand was simulated using a pres-sure-independent multi-yield surface plastic model.Clay material served as a nonlinear hysteretic material with a multi-surface kinematic plasticity model,and the pile group maintained its linear behavior in the process of calculation.The clay layer and saturated sand layer were meshed in a 20-node brick element and separately in a 20-8 node element.The boundary of the numerical model was considered as the shear beam boundary,which simulated the shear effect of the soil layer dur-ing the earthquake.Finally,the Rayleigh damping method was used to model the damping of the system.The dynamic response of each pile in pile group was compared,and it showed that the bending moment and displacement time history of piles at different depths developed in the same way,and the time of maximum bending moment and displacement of the pile appears to lag be-hind the time of peak acceleration of the input seismic wave.The maximum bending moment and displacement of the leading pile were larger than the those of the back piles.By comparing the maximum bending moment and displacement,it can also be concluded that,as depth increases,the maximum bending moment first increases and then decreases.The bending moment of the pile at the 2.5 m depth was greater than those at other depths.In terms of displacement,as depth in-creased,the maximum pile displacement decreased,and the maximum displacement of the pile head was greater than other observed points on the pile.This demonstrated the different behaviors of the pile bending moment response.In order to consider the effect of pile spacing on the pile group effect,several Finite Element models were developed for different pile spacing.This model-ing concluded that the maximum bending moment appeared to occur in the boundary of different soil layers.As pile spacing increased,the maximum bending moment and pile head displacement in the group increased.In the pile group with pile spacing equal to 7D (diameter),the maximum bending moment of the each pile was very close.The difference was about 3% when pile spacing was equal to 5D ,and the difference was about 4%,when pile spacing was equal to 3D .The maxi-mum bending moment of the first pile group was 10% larger than the bending moment of the sec-ond pile group.In the last part of the study,the cause of the pile group effect was analyzed and a basic understanding of the seismic design requirements for this type of pile group was obtained.

Dynamic Response and Load Distribution of Pile Groups in Layered Liquefiable Ground

Three Dimensional Numerical Simulation of Piles in Liquefiable Ground

Experimental and Numerical Investigation on the Dynamic Response of Pile Group in Liquefying Ground

Strong Seismic Response of Pile Group-soil Coupling System in Liquefied Ground

Dynamic Impedances and Free-Field Vibration Analysis of Pile Groups in Saturated Ground

Experimental and numeikal analysis of a 4x4 pile group in liquefiable ground

Finite Element Model for Piles in Liquefiable Ground

Analysis of the Bridge Pile Group Effect in Liquefaction-induced Lateral Spreading Sites

Lateral Dynamic Responses of Coastal Group Piles Considering Pile‒water‒soil Interactions

Dynamic Responses of Embedded Rock Pile Groups due to Rock Burst considering Coupled Pile-to-Pile Interaction

Response of pile groups in layered soil to dynamic lateral loads

Three-dimensional finite element analysis of shake-table test for dynamic pile behavior in liquefaction-induced lateral spreading ground

Effect of ground motion characteristics on seismic response of pile foundations in liquefying soil

Dynamic Response of Underground Structure under Bidirectional Shaking in Layered Liquefiable Ground

Numerical Simulations of Shake-Table Experiment for Dynamic Soil-Pile-structure Interaction in Liquefiable Soils

Study on Vertical Load Distribution of Pile Group–Liquefied Soil System under Horizontal Seismic Environment

Responses of Reinforced Concrete Pile Group in Two-Layered Liquefied Soils: Shake-Table Investigations

Study on the Dynamic Soil-Pile-Structure Interactive Behavior in Liquefiable Sand by 3D Numerical Simulation

Liquefaction-induced settlement of the pile group under vertical and horizontal ground motions

Dynamic response of pile groups subjected to horizontal loads

Lateral Spreading Near Deep Foundations and Influence of Soil Permeability