Numerical investigation of phase relationship between kinematic and inertial loads of piles behind a quay wall in liquefiable ground
Chunhui Liu,Jianliao Weng,Lijun Deng,Yongzhi Wang,Qinghe Fang
DOI: https://doi.org/10.1016/j.compgeo.2024.106265
IF: 5.218
2024-04-03
Computers and Geotechnics
Abstract:The kinematic effect induced by soil lateral spreading and the inertial effect from the superstructure may result in pile failure in liquefaction-induced lateral spreading ground. Current seismic guidelines on the combination of kinematic and inertial loads on pile are different. To investigate the phase relationship between the kinematic and inertial loads and the timing of the peak values of these two loads, nonlinear dynamic finite element analysis was conducted on a pile-superstructure-quay wall system in liquefiable ground. The numerical model was validated against the results of a large-scale shaking table test. Parametric investigations were then conducted to analyze the effects of the soil condition, pile property, and mass of superstructure on kinematic and inertial loads. The results show that the kinematic and inertial loads tended to act in-phase in scenarios with a large pile flexural stiffness, a small superstructure mass, a short pile length, and low undrained strength of clay, while acting out-of-phase in scenarios featuring the opposite conditions. The phase relationship between kinematic and inertial loads was observed to be related to the natural periods of the pile and the ground. When the ratio of the pile natural period to that of the ground was less than 0.99, the kinematic and inertial loads exhibited an in-phase relationship; otherwise, the two loads acted out-of-phase. The maximum inertial load occurred near the input peak acceleration, while the timing of the maximum kinematic loads varied with the soil, pile, and superstructure properties.
computer science, interdisciplinary applications,geosciences, multidisciplinary,engineering, geological