Abstract:In the traditional load model, motor and static loads are used to represent electrical equipment. However, since the electrical equipment using power electronic interface has accounted for a large proportion at present, the load components should be divided into motor, static load and power-electronic-interfaced load. The composition of the electric load is time-varying, and mastering the proportion of different load components is the key to establish an accurate load model. The existing load component proportion identification method identifies the key parameters of the load model and motor proportion parameters under large disturbances. However, the accuracy of this method is affected by the accuracy of load model parameters; moreover, it cannot identify the proportion of three types of load components. To this end, based on the analysis of different response characteristics of motor, static load and power-electronic-interfaced load under large disturbance, this paper proposes a load component proportion identification method based on dynamic response under large disturbance. This method first determines the proportion of static load according to the drop value of active power of load during the duration of large disturbance; then, the proportion of power-electronic-interfaced load is determined according to the separation results of motor response and the highest fitting accuracy; finally, the proportion of motor load can be calculated. The case study shows that the method does not depend on other parameters in the load model and has high identification accuracy.

Simplified Identification Strategy of Load Model Based on Global Sensitivity Analysis

Parameter Identification of Load Model Using Scatter Plot Based Global Sensitivity Analysis

Identifiability and Identification of a Synthesis Load Model

Parameter Identification of the Synthesis Load Model Considering Distribution Impedance and Compensation Capacitor

Identifiability Analysis of Load Parameters Based on Sensitivity Calculation

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

Parameters Determination of Synthesis Load Model Considering Distribution Network Connection

Comparative Study of Global Sensitivity Analysis and Local Sensitivity Analysis in Power System Parameter Identification

Model structure of generalized load and combined method for parameter determination

Parameter estimation and comparison of the load models with considering distribution network directly or indirectly

Improvements and measurements of parameter identification for electric load

Electrical load modeling with considering distribution network

Probabilistic Preassessment Method of Parameter Identification Accuracy with an Application to Identify the Drive Train Parameters of DFIG

Identification Method of the Load Component Proportion Based on the Dynamic Response under Large Disturbance

Synthesis Load Model with Ideal Transformer

Parameters identification of practical load model with voltage phase considered

Parameter identification of electric loads based on second-order sensitivity

Identification of a composite load model with applications

A Two-Step Method for Online Parameter Identification of a Simplified Composite Load Model

Ambient Signal Based Load Model Parameter Identification Using Optimization Method

Simplification Scheme for Power System Composite Load Model and Selection of Identification Parameters Set