Abstract:In the composite load model (CLM), which is commonly used in China, an equivalent motor and equivalent static load are used to represent all electrical equipment and networks connected to a load bus. Existing research has determined typical values of electrical and mechanical parameters for load models of different load types, which improves the basis for load modeling. However, the motor proportion parameter is not the same for different load buses or at different times; therefore, obtaining the actual motor proportion is key to establishing an accurate load model. In the existing load modeling method, motor proportion is commonly identified along with other parameters under rare large disturbances; therefore, the value of the motor proportion is fixed by the time when a large disturbance occurs. In this paper, formulae are derived to estimate motor proportion under small disturbances, and these formulae allow direct calculation of motor proportion without using any optimization algorithm. The proposed estimation formulae do not rely on any parameters of load model or power system but instead rely only on measurement of the voltage and active power at steady-state points before and after a small disturbance. Because of universality of small disturbances in power systems, estimating time-varying motor proportion under small disturbances will be helpful for solving the time-varying problem of load models. Finally, the proposed motor proportion estimation formulae are validated by simulations, physical experiments, and field experiments.

Parameters Determination of Synthesis Load Model Considering Distribution Network Connection

Electrical load modeling with considering distribution network

Parameter estimation and comparison of the load models with considering distribution network directly or indirectly

Identifiability and Identification of a Synthesis Load Model

Parameter Identification of the Synthesis Load Model Considering Distribution Impedance and Compensation Capacitor

Calculation Method of the Equivalent Impedance of a Distribution Network Based on Power Loss

Synthesis Load Model with Ideal Transformer

Model structure of generalized load and combined method for parameter determination

An Identifiability Analysis of a Synthetic Load Model with the Distribution Network Considered

Generalized Load Modeling of Distribution Network Integrated with Direct-drive Permanent-magnet Wind Farms

A new generalized load model of power systems and its applications

Feasibility Study on the Characterization of Electric Load including Inverter Air Conditioner with a Synthetic Load Model

Parameters identification of practical load model with voltage phase considered

Load Modeling Including Air Conditioners

Mechanism Analysis of Power Load Using Difference Equation Approach

Improvements and measurements of parameter identification for electric load

Modeling Methods for Electric Loads in a Real Power Grid

Online Synthetic Load Modeling System for Fujian Power Grid

Component Based On-line Modeling for Electric Loads

Composite Load Models Based on Field Measurements and Their Applications in Dynamic Analysis

Analytic Formulae for Estimating Motor Proportion of Load Model under Small Disturbance