Abstract:Study on the corrosion behavior of reinforcing steel is one of the most significant research topics in the field of corrosion and protection of metals. The scanning microelectrode technique is a powerful tool to study localized corrosion behavior of reinforcing steel in a corrosive solution. In this work, the corrosion behavior of reinforcing steel in a simulated concrete pore solution with Cl - and the inhibition effect of a mixture of NaNO 2 and Na 2 SiO 3 on the steel were studied by the scanning microelectrode technique assisted by polarization curve measurements and surface analyses. Q235 reinforcing steel was used as the tested material. The cylindrical steel specimen with dimension of Æ1.14 cm ´ 0.50 cm was sealed in a PVC holder enveloped with epoxy resin, and only a cross section (1.00 cm 2 ) of the steel served as the working surface. Before experiments, the steel specimen was sequentially polished by silicon carbide sandpaper up to 1500 grit and 0.3 µm Al 2 O 3 powder, and then ultrasonically cleaned in deionized water and ethanol. A saturated Ca(OH) 2 solution was used as the simulated concrete pore (SCP) solution. The simulated polluted concrete pore (SPCP) solution was prepared from SCP solution by adjusting its pH to 11.50 with deionized water and adding 0.05 M NaCl. NaNO 2 and Na 2 SiO 3 with different concentrations as corrosion inhibitors were added to the SPCP solution. The potential distribution on the reinforcing steel surface was measured by a home-built scanning microelectrode measurement system. Ag/AgCl electrodes were used as a scanning microprobe and a micro-reference electrode. Polarization curve measurements were carried out by an Autolab Potentiostat Galvanostat. A three–electrode cell was used with the steel specimen as the working electrode, a saturated calomel electrode (SCE) as the reference electrode and a platinum electrode as the counter electrode. All the measurements were performed at ambient temperature. The results showed that there were no stable large potential peaks on the steel surface in the pure Ca(OH) 2 solution with pH 12.50 or 11.50, indicating that the steel surface was in a passive state and no corrosion took place. For the steel in the SPCP solution with 0.050 M NaCl and pH 11.50, a stable and large local potential peak occurred on its potential map after 20 min immersion. This result indicated that the steel was active and localized corrosion occurred resulting from the Cl - attack. For the SPCP solution with 0.004 M NaNO 2 and 0.001 M Na 2 SiO 3 , there were no stable potential peaks on the potential map of the steel immersed in the solution for 8 h, indicating that no localized corrosion took place. Therefore, the mixture of NaNO 2 with Na 2 SiO could protect the reinforcing steel from corrosion. The polarization curve measurements and surface analyses also confirmed the above results. This work was supported by the National Natural Science Foundation of China (Nos. 21073151, and 21173177).

Research on the Influencing Factors on the Corrosion Resistance of Rebars in Concrete

Research Progress in Corrosion Behavior and Anti-Corrosion Methods of Steel Rebar in Concrete

Different Effects of Fly Ash and Slag on Anti-Rebar Corrosion Ability of Concrete with Chloride Ion

EXPERIMENTAL STUDY ON REBAR CORROSION EMBEDDED IN CONCRETE AFFECTED BY MINERAL ADMIXTURE

EXPERIMENTAL STUDY ON CORROSION OF REBAR

Effects of Different Coatings, Primers, and Additives on Corrosion of Steel Rebars

Influence of Rust Inhibitor on the Corrosion Resistance of Reinforcement in Cement Paste with Chloride

Corrosion Resistance of Cr-bearing Rebar in Concrete with Chloride Ion Content

Research on Chloride Appropriate Dosage for Incorporated Accelerated Corrosion

The influence of longitudinal rebar type and stirrup ratio on the bond performance of reinforced concrete with corrosion

Study on Corrosion Inhibition of Reinforcing Steel in Simulated Concrete Pore Solutions by Scanning Microelectrode Technique

Exploration into Anticorrosive Property of Antirust Compound-Admixture

Corrosion Behavior of Cr-Ni Alloyed Corrosion Resistant Rebar in Chloride Environment

Effect of Nano-SiO2/PVA on Corrosion Behavior of Steel Rebar Embedded in High-Volume Fly Ash Mortar under Accelerated Chloride Attack.

Corrosion Behavior of Cr/RE Alloyed Rebar in Carbonated Simulated Concrete Pore Solutions with Chloride Ions

Time-varying law of rebar corrosion rate in fly ash concrete

Corrosion Resistance of Cr-bearing Rebar in Simulated Concrete Pore Solutions

The Influence of Mineral Admixtures on Resistance to Corrosion of Steel Bars in Green High-Performance Concrete

The Corrosion Resistance of Reinforced Reactive Powder Concrete with Secondary Aluminum Ash Exposed to NaCl Action

Surface Modification of Rusted Rebar and Enhanced Passivation/Anticorrosion Performance in Simulated Concrete Pore Solutions with Different Alkalinity

Electrochemical Corrosion Behavior of Carbon Steel Reinforcement in Concrete Containing Limestone and Mesoporous Silica Nanoparticles under Acidic Environment