Abstract:The forming characteristics of splitting spinning based on the behaviors of roller is one important key of improvement of materials forming limit and forming precision. In this paper, the relationship between continuous feed conditions and feed amount of roller is obtained by the static analysis of splitting spinning. Based on the numerical relationship, the forming characteristics of splitting spinning based on the behaviors of roller is studied, including geometric parameter, boundary condition and contact. According to the above analysis of forming characteristics, a 3D elastic–plastic FE model of splitting spinning is established using the dynamic explicit FE code ABAQUS/Explicit, and then the reliability is proved by comparisons with experimental data. Furthermore, the influence laws of forming parameters of splitting spinning on the quality and precision of flanges are investigated under different forming conditions. The results are as follows: (1) On the conditions of 20⩽α⩽45° and r0=1.5mm, deformed flanges satisfy high quality and high precision. (2) When feed rate 1.0<v<2.94mm/s, thickness deviation changes comparatively even, probably holding from 10% to 20%, and when rotation speed of mandrels ω⩽70round/min, both the angle deviation of inner-face/outer-face goes towards zero. (3) The variation of friction coefficients between contact surfaces influencing on the degree of inhomogeneous deformation and thickness deviation of deformed flanges is notable, and influencing on the angle deviation is steady and even enough to obtain high quality and high precision. The forming characteristics of splitting spinning based on the behaviors of roller are revealed, and meanwhile the relative slip between roller and the workpiece and the non-uniform rotation and reverse rotation of roller may be avoided. The results may help to better understand the forming characteristics of splitting spinning based on the behaviors of roller and improve materials forming limit and forming quality.

Influence of Surface-profile and Movement-path of Roller on Thickness Thinning During Multi-pass Deep Drawing Spinning

Effects of Forming Parameters on Deformation Uniformity of Thin-walled Parts during Multi-pass Spinning

Research on the influence of roller structure on forming quality of high-strength steel during flow spinning forming

Dynamic Optimization of Die-Less Spinning Process Through Autonomous Modeling of Time-Varying Forming Law

Forming dependence on spin roller paths for thin-walled complex components from 2195 Al-Li alloy TWBs

A Numerical Study of the Effects of Roller Paths on Dimensional Precision in Die-Less Spinning of Sheet Metal

Influence of roller-trace on multi-pass conventional spinning process

Influence of Blank Thickness Fluctuation on Flange State and Final Thickness Distribution in the Power Spinning of Thin-Walled Head

Determination of Formability Considering Wrinkling Defect in First-Pass Conventional Spinning with Linear Roller Path

Influence of processing parameters on the forming quality of high strength steel tube during single pass neck-spinning

Wall Thickness Variation During Multi-Pass Spinning of Large Complicated Shell

Online Pre-Perception of Forming State Based on Real-Time Measurement in Spinning of Thin-Walled Shell Component

Influences of Roller Parameters on Power Spinning of Large Ellipsoidal Heads with Variable Thickness

A study of the one-path deep drawing spinning of cups

Influence of Process Parameters on Spinning Force and Wall Thickness Difference of Shear Spinning

Influence of Process Parameters on Conventional Spinning Formation Process

Advances in Spinning of Aluminum Alloy Large-sized Thin-walled and Special-curved Surface Head

Investigation on Dimensional Accuracy and Mechanical Properties of Cylindrical Parts by Flow Forming

Forming Characteristics of Splitting Spinning Based on the Behaviors of Roller

Numerical Simulation of Influence of Roller Working Surface on Spin-Forming of Rectangular Inner Meshing Gear

A two-step symmetrical thickening spinning process for disk-shaped part